Q codes and ham radio shorthand: what QRM, QRN, QRP, QSL, QTH, 73, K, KN, SK and RST actually mean
- Replies 2
- Views 112
- Created
- Last Reply
Top Posters In This Topic
-
Admin_Terry 1 post
-
Mod_Tom 1 post
A better way to browse. Learn more.
A full-screen app on your home screen with push notifications, badges and more.
Newer hams often ask how much of the shorthand they need to know before getting on the air. On CW it's everywhere, and on phone you'll hear a few Q codes and some odd phrases. Here's a starting list, and corrections are welcome.
The Q codes you'll hear most
Q codes began as three-letter shortcuts for CW. Each one can be a question (with a question mark) or a statement.
QRM is interference from other stations or man-made sources. QRN is natural noise, such as static from thunderstorms. QRP means low power, and QRO means high power. By convention QRP is usually 5 watts or less on CW, with a slightly higher figure often used for SSB. QRT means stop sending or shut down, as in 'I'm going QRT for the night.' QRZ? means 'who is calling me?', and you'll hear it when someone caught only part of a callsign. (QRZ.com is a separate callsign lookup website, not the code itself.) QRL? asks 'is this frequency in use?' The answer or statement 'QRL' means it is busy.
QSL means 'I acknowledge receipt.' It is also the name for the confirmation card or electronic confirmation of a contact. QSO is a two-way contact. QSY means change frequency, QTH means location, and QSB means the signal is fading in and out.
Calling and ending
CQ is a general call to any station. DE means 'from.' A typical CW call is: CQ CQ CQ DE W1ABC W1ABC K. Put together, that says 'calling any station, this is W1ABC, go ahead.' K means 'go ahead, anyone.' KN means 'go ahead, but only the station I named.' SK is the prosign for the end of a contact. Separately, 'silent key' (also SK) is how hams refer to an amateur who has died.
73 means best regards, and 88 means love and kisses, so it is usually reserved for a spouse or close friend. Because 73 is already plural, 'seventy-threes' is redundant, though you'll still hear it.
RST
RST stands for Readability (1 to 5), Signal strength (1 to 9) and Tone (1 to 9). Tone applies only to CW, so on phone you give just RS, such as 'five nine.' A report of 599 is common in contests, and it is often sent without much thought. A report is more useful when it reflects what you actually heard.
What other shorthand do people run into, and which of these cause the most confusion?
Link to comment
https://www.hamradiobase.com/forums/topic/10792-q-codes-and-ham-radio-shorthand-what-qrm-qrn-qrp-qsl-qth-73-k-kn-sk-and-rst-actually-mean/Share on other sites