Building a lightweight field kit: EFHW or linked dipole on a telescopic pole, and how much battery do you really need?
- Replies 2
- Views 35
- Created
- Last Reply
Top Posters In This Topic
-
Admin_Terry 1 post
-
Mod_Dan 1 post
I'd like to compare notes on the basics of a portable kit that works for both SOTA and POTA. A summit with a long hike and a park where you can drive up to the picnic table call for different kits, but a lot of the core decisions are the same. Here are the pieces I think matter most, so people can disagree with me.
Antenna choice. An end-fed half wave (EFHW) is popular because you only need one wire, a matching unit (usually 49:1 or 64:1), and a way to hold up the far end. A wire cut for 40 m is roughly 20 m (about 66 ft) long and is also usable on 20, 15 and 10 m, since those are harmonically related. The tradeoffs are that the transformer can get warm at higher power, the feedline and radio often become part of the antenna, and a short coax run with a choke or counterpoise is often worth the extra few grams. A linked dipole is center-fed and balanced, and you change bands by connecting or disconnecting links in the wire. It's very predictable and easy to troubleshoot, but you have to stop and change links, and it's easy to lose a link or mix up the legs in the dark or the cold.
Support. A 10 m class fiberglass telescopic pole is a common choice. It can hold a linked dipole as an inverted V, or hold the far end of an EFHW as a sloper or inverted L. Whatever you use, guy it if there's any wind, and tape or clamp the sections so they don't creep down. Wipe the sections and keep grit out, because that's what makes them stick and wear. Setting up away from power lines is not optional. Fiberglass isn't a safety guarantee, especially when it's wet or dirty.
Power. For 5 to 20 W SSB/CW/FT8, a small LiFePO4 pack is a good fit. Nominal voltage is 12.8 V (4S), full charge is around 14.4 to 14.6 V, and under load it stays flat for most of its capacity, so your radio is happy right until the battery protection cuts out. Check that your radio tolerates the full-charge voltage. Put a fuse close to the battery, use proper connectors, and don't charge LiFePO4 below freezing unless the pack is explicitly rated for it. For solar, use a controller with a LiFePO4 profile instead of wiring a panel straight to the battery. Solar is nice for a long park session or a Field Day style site, but on a summit it's often just extra weight.
Logging. Paper and pencil never run out of battery and are fine on a wet day. For activations, remember that SOTA needs four contacts for the summit to count and POTA needs ten contacts in a UTC day. Write down UTC time, band, mode, callsign and reference, and enter it into your logger later, or use a logging app if you trust it with cold hands. Keep a backup either way.
Weather and safety. Tell someone where you're going and when you expect to be back. Pack for the temperature drop you'd get at the top, not at the trailhead. If thunder is close, take the antenna down and get off the exposed spot. Radio is not worth it. Wind can turn a pole into a sail, so it's better to lower it early than to rescue it.
So what's in your kit that you'd never leave behind, and what did you stop bringing because it wasn't worth the weight? I'm especially curious about EFHW versus linked dipole for someone doing mostly POTA with the occasional SOTA.
Link to comment
https://www.hamradiobase.com/forums/topic/10822-building-a-lightweight-field-kit-efhw-or-linked-dipole-on-a-telescopic-pole-and-how-much-battery-do-you-really-need/Share on other sites