Run vs. search-and-pounce: how do you decide when a multiplier is worth leaving a good run frequency?
- Replies 2
- Views 48
- Created
- Last Reply
Top Posters In This Topic
-
Admin_Terry 1 post
-
Mod_Nancy 1 post
A better way to browse. Learn more.
A full-screen app on your home screen with push notifications, badges and more.
The run-versus-S&P question looks simple, but the decision is really about marginal value. In most multiplier-based contests, score is roughly (QSO points) x (multipliers). Adding one QSO raises the score by about 1/Q, and adding one multiplier raises it by about 1/M. So a new multiplier is worth about Q/M average QSOs. With 2,000 QSOs and 300 multipliers, one new mult is worth roughly 6 to 7 contacts. Early in the contest, when M is small, mults are worth far more QSOs. Late in the contest, with M large and Q still climbing, the balance shifts toward rate.
That gives a usable rule: if you can find and work a multiplier in less time than it takes to make Q/M contacts at your current rate, go get it. At a steady 120/hour, six QSOs cost about three minutes. A mult that takes 30 seconds of tuning and one call is a bargain. A mult that takes five minutes of pileup fighting probably isn't, unless it's rare and won't come around again.
Some practical questions I'd like to hear opinions on:
1. Rate meter discipline. N1MM's rate display (last 10 and last 60 minutes) is easy to ignore. Do you set a threshold, say "if the 10-minute rate drops below X, stop calling CQ and go hunting," or do you go by feel? Short-term rate is noisy, so a dip may just be a lull between callers.
2. Band changes. In contests with per-band multipliers, a band change gives you a fresh set of mults and often a new pool of callers. The cost is the QSY itself, plus the time to find a clear run frequency and rebuild momentum on the new band. Do you plan changes by clock, for example around gray line or expected openings, or react to rate and propagation?
3. Spotting. A skimmer feeding the bandmap, or cluster spots over packet or telnet, makes S&P much faster. Keep in mind that using spots usually puts you in an assisted category, while unassisted entrants have to find stations by tuning. Rules differ between contests, so read the current rules for yours, especially on self-spotting and on whether decoding with a local skimmer counts as assistance.
For single-operator stations with only one radio, the big question is how much time to give each mode. For two-radio stations, SO2R changes the whole calculation, since the second radio can hunt mults while the first one runs. I'd like to see how people here approach both.
Link to comment
https://www.hamradiobase.com/forums/topic/10835-run-vs-search-and-pounce-how-do-you-decide-when-a-multiplier-is-worth-leaving-a-good-run-frequency/Share on other sites