Skip to content
View in the app

A better way to browse. Learn more.

Ham Radio Base

A full-screen app on your home screen with push notifications, badges and more.

To install this app on iOS and iPadOS
  1. Tap the Share icon in Safari
  2. Scroll the menu and tap Add to Home Screen.
  3. Tap Add in the top-right corner.
To install this app on Android
  1. Tap the 3-dot menu (⋮) in the top-right corner of the browser.
  2. Tap Add to Home screen or Install app.
  3. Confirm by tapping Install.
Ham Radio Base — Education, Resources, Projects and Community
☀ Solar
SFI 99
SN 26
A 6
K 0 Quiet
X-Ray B2.3
Wind 412.9 km/s
Aurora 1
Updated 14:00 UTC HamQSL · N0NBH
Day 80/40m Good 30/20m Good 17/15m Fair 12/10m Poor
Night 80/40m Good 30/20m Good 17/15m Fair 12/10m Poor

Callsign Lookup
_
Vanity Call Signs Available
Enter filters above and click Search.
ⓘ Callsign lookups are in real time via the FCC database. Vanity callsign availability is refreshed daily at 6:00 AM CST. The vanity search may be unavailable for a few minutes during this update.
Live DX spots
Live DX Spots — 70cm via PSKReporter · scroll or pinch to zoom
Band
Mode
Time
Loading map data…
MHz DX Spotter Info
Recent spots —
Select a band above to load spots
Ready — select a band to fetch live spots

J-pole, slim jim, 5/8 wave or yagi? Matching VHF/UHF antennas to polarization, pattern and feedline

ci_cover.jpg

Most VHF/UHF antenna problems come from a mismatch between the antenna type and the job, not from a bad antenna. This thread is a place to compare the common options and the parts around them (coax, connectors, mounts), because the feedline and installation often matter more than the antenna's catalog gain figure.

Simple verticals. A quarter-wave whip is about 19 inches on 2 m (roughly 6.5 inches on 70 cm). It needs a ground plane, such as a vehicle roof or radials, and has a fairly low-angle pattern with about unity gain over a ground plane. A 5/8-wave whip is longer and usually has a base matching coil. In theory it concentrates energy a little closer to the horizon, and gain figures of a couple of dB over a quarter-wave are typical, but real numbers depend heavily on the ground plane. A small or off-center ground plane can tilt the pattern upward and cost you the benefit.

J-pole and slim jim. Both are end-fed half-wave designs, with a quarter-wave matching section in the J-pole. Neither needs radials in the way a quarter-wave does, which is why they are popular as home-built antennas from ladder line, copper pipe or twin-lead. Gain is modest, roughly half-wave dipole territory, and vendor claims vary. The usual practical issue is common-mode current on the coax, which distorts the pattern and moves the SWR when you touch the cable. A choke (ferrite beads or a few turns of coax) near the feedpoint helps. A slim jim's folded design gives it a slightly lower takeoff angle than a J-pole, but you should treat any big gain number with suspicion.

Collinears. Stacking in-phase elements squeezes the vertical pattern. Ideally each doubling of the radiating section adds about 3 dB, but real antennas fall short because of phasing losses. The tradeoff is a narrower elevation beamwidth, so a high-gain omni can overshoot users who are close and well below it, for example from a hilltop. Mounting it away from the mast and keeping the mast vertical both matter.

Yagis. A yagi gives directional gain and front-to-back rejection. It can null out interference as well as reach a distant repeater or station. Polarization is the catch. FM simplex and repeaters are almost always vertical, while weak-signal SSB/CW work on 2 m and 70 cm is conventionally horizontal. Cross-polarized signals can lose a lot, and the loss is rarely as clean as the theoretical figure because reflections scramble polarization.

Coax and connectors. Loss rises quickly with frequency. Rough figures per 100 ft are: RG-58 about 4.5 dB at 150 MHz and around 9 dB at 450 MHz; LMR-400-class cable about 1.5 dB and 2.7 dB. Always check the manufacturer's datasheet. A PL-259 (UHF connector) is fine for HF and workable on 2 m, but it is not constant-impedance and is a poor choice for 70 cm and above, especially outdoors. N-type is constant-impedance, better sealed and a better fit for UHF and permanent installs. Seal outdoor connectors with self-amalgamating tape plus a UV-resistant outer wrap, and leave a drip loop.

SWR. SWR indicates match, not efficiency. A 1.5:1 SWR reflects roughly 4% of power, and 2:1 about 11%, which is rarely the main loss. A dummy-load-quality reading through a long run of lossy coax can look excellent because the loss hides the reflection. If possible, measure at the antenna end of the cable with an analyzer or VNA and check where the resonance actually sits.

Questions to get things started: for a fixed 2 m/70 cm base station, when does a homemade J-pole or slim jim make sense over a commercial collinear? And for a vehicle, how much does ground-plane geometry change the real-world difference between a 1/4-wave and a 5/8-wave?

  • Replies 2
  • Views 40
  • Created
  • Last Reply

Top Posters In This Topic

Featured Replies

  • Moderators

On the mobile side, NMO is usually the best choice if you are willing to drill a 3/4 inch hole. It gives a solid mechanical connection and a good ground contact through the body of the mount to the roof. The roof center gives the most symmetrical pattern. Moving the antenna to a fender or trunk lip skews it, and the pattern gets blocked in the direction of the vehicle body. A mag mount is the quick alternative, but a plain magnetic base couples to the metal capacitively. Rust, paint or dirt, or a mount sitting on a ribbed roof, can shift the SWR and cause intermittent behavior. Wiping both surfaces clean before placement is a cheap fix.

For 5/8-wave versus quarter-wave, the 5/8's advantage is more about lower elevation angle than a raw gain figure. It also loses much of that edge if the ground plane is small, which is common on small cars and on trunk-lip mounts. A quarter-wave is more tolerant and also much simpler to tune. On 70 cm the whips are short and the ground plane problem is less severe, so a dual-band antenna that uses a longer radiator on 70 cm can have a rather different pattern than on 2 m. Check the manufacturer's pattern notes if you care about it.

As for connectors, mag mounts often come with a PL-259 on thin RG-58-type cable. That is fine for short mobile runs at 2 m. At 70 cm the cable loss starts to matter, and an inexpensive PL-259 adds uncertainty. If you are building your own mobile cable, a crimped or well-soldered connector is a more reliable option than a poorly installed one. Route the cable under door seals carefully so it does not get pinched, since a crushed coax is a common cause of a high SWR that 'comes and goes'.

  • Moderators

One thing worth adding is repeater and satellite use, since the right antenna is almost the opposite for the two.

For repeater access, a vertical omni or a vertical yagi pointed at the repeater is the usual approach. If you are weak into the repeater but can hear it fine, a small yagi (3 to 5 elements) may help more than a bigger omni, since it improves the transmit and receive link in one direction, and also reduces pickup from other directions. At a repeater site the antenna is typically a high-gain collinear fed with low-loss hardline, with a duplexer or separate antennas for transmit and receive. When separate antennas are used, vertical separation is much more effective than horizontal separation for isolation.

Satellites are a different problem. Most amateur satellites transmit on 2 m and 70 cm with linear polarization from the satellite's point of view, but the polarization seen on the ground changes as the satellite tumbles and moves. That is why circular polarization (commonly a crossed yagi, with right-hand circular as the usual choice) is common for fixed tracking setups. Many people working FM LEO satellites use a handheld directional yagi and simply rotate the antenna as the signal fades. Doppler shift on 70 cm is also large enough that you need to retune during a pass, and full-duplex operation (hearing your own downlink while you transmit) helps with that. A simple J-pole or ground-plane antenna can work for the strongest passes at high elevation, but the low-elevation parts of a pass usually need gain and pointing.

Also a reminder about safety. Keep any mast and antenna well clear of power lines, including when it is being raised, and be careful with the RF exposure limits of higher-power setups when an antenna is mounted close to living areas.

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

Affiliate Disclosure: As an Amazon Associate, Ham Radio Base earns from qualifying purchases. Some links throughout this website may be affiliate links. If you purchase a product through one of these links, we may earn a commission at no additional cost to you. Your support helps us continue creating free articles, tutorials, reviews, and resources for the amateur radio community. N0TLB © Ham Radio Base - Powered by the Ham CQ DX Community. All rights reserved.

Search

Search

Configure browser push notifications

Chrome (Android)
  1. Tap the lock icon next to the address bar.
  2. Tap Permissions → Notifications.
  3. Adjust your preference.
Chrome (Desktop)
  1. Click the padlock icon in the address bar.
  2. Select Site settings.
  3. Find Notifications and adjust your preference.