Skip to content
View in the app

A better way to browse. Learn more.

Ham Radio Base

A full-screen app on your home screen with push notifications, badges and more.

To install this app on iOS and iPadOS
  1. Tap the Share icon in Safari
  2. Scroll the menu and tap Add to Home Screen.
  3. Tap Add in the top-right corner.
To install this app on Android
  1. Tap the 3-dot menu (⋮) in the top-right corner of the browser.
  2. Tap Add to Home screen or Install app.
  3. Confirm by tapping Install.
Ham Radio Base — Education, Resources, Projects and Community
☀ Solar
SFI 99
SN 26
A 6
K 0 Quiet
X-Ray B2.3
Wind 384.8 km/s
Aurora 1
Updated 13:30 UTC HamQSL · N0NBH
Day 80/40m Good 30/20m Good 17/15m Fair 12/10m Poor
Night 80/40m Good 30/20m Good 17/15m Fair 12/10m Poor

Callsign Lookup
_
Vanity Call Signs Available
Enter filters above and click Search.
ⓘ Callsign lookups are in real time via the FCC database. Vanity callsign availability is refreshed daily at 6:00 AM CST. The vanity search may be unavailable for a few minutes during this update.
Live DX spots
Live DX Spots — 70cm via PSKReporter · scroll or pinch to zoom
Band
Mode
Time
Loading map data…
MHz DX Spotter Info
Recent spots —
Select a band above to load spots
Ready — select a band to fetch live spots

Run vs. S&P, SO2R, and rate: how do you decide when to leave a frequency?

ci_cover.jpg

I'd like to compare how people make the run-versus-search-and-pounce decision, because the right answer seems to change with the contest, the band, and the category. Here are the main points I'd put on the table.

Rate is the baseline, but not the whole story. A run frequency on a good band can keep a steady rate for hours. The question is whether that rate is still the best use of the minute. Watch your 10-minute and 60-minute rates in N1MM. When the 10-minute rate sags well below the hourly rate, the band may be changing, or you may have worked everyone who can hear you. It may also be time to check the bandmap for new multipliers before the next CQ.

Multipliers change the math. In a contest where each new multiplier is worth many QSO points, a short S&P excursion can beat another few minutes of CQing. In contests where multipliers are plentiful or easy to find, staying put and running usually wins. The practical rule is to check the exchange and scoring rules first, then estimate what one new multiplier is worth against the QSOs you would lose while away from your run frequency.

Band changes cost something. A band change means more than switching the antenna and radio. You lose your held frequency, and you have to find a clear spot and rebuild a run. Many operators plan changes around propagation: moving up as the higher bands open, and moving down as they close. Some contests also limit band changes in certain multi-operator categories, so read the rules for your category.

Where SO2R fits. With a second radio, you can search the second band for multipliers while the first radio keeps calling CQ. The skill is in the switching. Audio routing, headphone focus, and keeping the CQ cadence going without stepping on yourself all take practice. For most people the first improvement comes from using the second radio only for obvious multipliers, then adding more S&P as the switching becomes natural. Interlocks and good transmit inhibit are not optional, because they prevent you from transmitting on both radios at once.

Skimmer and spotting. A local CW Skimmer feeding N1MM's bandmap can show what is on the band while you run. Packet or RBN spots can help even more, but they put you in an assisted category in many contests. Before you plan a strategy around spots, check whether your category allows them and whether local decoding counts as assistance under the rules. Also remember that spots can be wrong, so listen before you commit.

Fatigue is part of the strategy. Planned rest often beats heroic operating. Scheduling breaks during dead band periods, and not during a hot opening, protects the hours that count. Food, water, a comfortable chair, and a reasonable noise level matter more than most people expect over a 24- or 48-hour event.

Where do you draw the line for leaving a run? Do you have a fixed rate threshold, or do you go by the multiplier picture and the band conditions?

  • Replies 2
  • Views 36
  • Created
  • Last Reply

Top Posters In This Topic

Featured Replies

  • Administrators

I'd start with the category, because it determines how aggressive the strategy can be. Single-op unassisted, single-op assisted, QRP, low power, and high power all reward different habits. In an assisted category, spots can make S&P much more efficient. In unassisted, your own ears and a local skimmer, where permitted, do all the work. Read the rules for the specific contest, because definitions and allowed tools vary.

For leaving a run frequency, a fixed rate threshold can mislead. A rate drop from a QSB fade is different from a drop caused by running out of stations. If the bandmap shows several unworked multipliers while your rate is flattening, going to S&P is usually the better trade. If the bandmap is quiet and you are still getting callers between CQs, staying is often right. One thing that helps is to decide before the contest roughly what a multiplier is worth in QSOs, so you aren't improvising under pressure.

  • Moderators

On SO2R, I'd focus on making the switching boring before making it clever. Keep the CQ message length and cadence consistent so you know when you have time to check the other radio. Use the second radio to look for a single clear target, not to scan the whole band. Then return to the first radio before the gap becomes obvious to callers.

Equipment matters for this. A proper SO2R interface or controller with transmit lockout, plus band-pass filters and stub filters where needed, helps prevent receiver desense and the dreaded double-key. Antenna separation and band choice also decide how well it works. Running two radios on adjacent bands with antennas close together is a harder problem than using widely separated bands. Antenna choice for contesting is usually about getting a reliable signal on the bands that matter most. A few well-matched antennas with good switching often beat a large number of marginal ones.

As for fatigue, an SO2R operator should probably plan more breaks, not fewer, because the mental load is higher than with one radio. Dropping back to a simpler single-radio approach late in the event is perfectly reasonable if your accuracy starts to slip.

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

Affiliate Disclosure: As an Amazon Associate, Ham Radio Base earns from qualifying purchases. Some links throughout this website may be affiliate links. If you purchase a product through one of these links, we may earn a commission at no additional cost to you. Your support helps us continue creating free articles, tutorials, reviews, and resources for the amateur radio community. N0TLB © Ham Radio Base - Powered by the Ham CQ DX Community. All rights reserved.

Search

Search

Configure browser push notifications

Chrome (Android)
  1. Tap the lock icon next to the address bar.
  2. Tap Permissions → Notifications.
  3. Adjust your preference.
Chrome (Desktop)
  1. Click the padlock icon in the address bar.
  2. Select Site settings.
  3. Find Notifications and adjust your preference.