Repeater basics to linked systems: offsets, tones, etiquette, and what changes when the machine is linked
- Replies 2
- Views 55
- Created
- Last Reply
A better way to browse. Learn more.
A full-screen app on your home screen with push notifications, badges and more.
This thread is for sorting out the repeater questions that come up again and again, from analog FM through the linked and digital systems. Add corrections and local variations, because band plans and habits differ by region.
Offset and tone basics. A repeater listens on its input frequency and retransmits on its output frequency. Your radio transmits on the input and receives on the output. The offset is the gap between them. Common US-style conventions are 600 kHz on 2 m (plus or minus depending on the sub-band), 5 MHz on 70 cm, and 1.6 MHz on 1.25 m. Other regions use different splits, so check your local band plan or a directory instead of assuming. Many repeaters also require a CTCSS tone (often called PL, a Motorola trade name) on your transmit signal before they will open. In most radios, plain "Tone" means encode only. "Tone Squelch" (TSQL) means your radio also stays muted until it hears that tone on received audio. DCS does the same job with a digital code (like D023N, where N and I mean normal and inverted polarity) instead of a sub-audible tone.
Open, closed, and coordinated. An open repeater is available to any properly licensed amateur in range, even if it needs a tone to access. A closed repeater limits use to members or approved users, often under rules set by the owning club. Many areas have a volunteer frequency coordinator who tries to prevent two repeaters from interfering with each other. Coordination is usually voluntary, but in some jurisdictions (the US, for example) a coordinated repeater gets favorable treatment when interference disputes arise. A club or owner will often publish the access tone, offset, and any membership or donation expectations in a directory entry or on their website.
Linking and digital systems. Once a repeater is linked, your transmission may be heard far beyond local coverage, so the etiquette changes a bit. Here is a quick map of the main systems:
EchoLink uses VoIP and requires callsign validation. Nodes are reached by number, and the repeater owner decides whether to permit connections. IRLP is a similar idea built around numbered nodes and reflectors, controlled by DTMF. It has faded in some areas, so confirm a node is still active before relying on it. AllStarLink is Asterisk-based and uses node numbers with hubs and DTMF commands. Wires-X is the Yaesu System Fusion approach, with nodes and rooms. DMR is a time-division system with two timeslots, color codes, and talkgroups, and you need a registered DMR ID plus a correctly built codeplug. D-STAR uses callsign routing and reflector connections, with settings like MYCALL, URCALL, RPT1, and RPT2.
Questions to get started: What do you check before you transmit on a repeater you have never used? What do newcomers most often get wrong about tones, timeout timers, or linked-system etiquette? And how should clubs share access information so people do not have to guess?
Link to comment
https://www.hamradiobase.com/forums/topic/10935-repeater-basics-to-linked-systems-offsets-tones-etiquette-and-what-changes-when-the-machine-is-linked/Share on other sites