Skip to content
View in the app

A better way to browse. Learn more.

Ham Radio Base

A full-screen app on your home screen with push notifications, badges and more.

To install this app on iOS and iPadOS
  1. Tap the Share icon in Safari
  2. Scroll the menu and tap Add to Home Screen.
  3. Tap Add in the top-right corner.
To install this app on Android
  1. Tap the 3-dot menu (⋮) in the top-right corner of the browser.
  2. Tap Add to Home screen or Install app.
  3. Confirm by tapping Install.
Ham Radio Base — Education, Resources, Projects and Community
☀ Solar
SFI 99
SN 26
A 6
K 0 Quiet
X-Ray B2.3
Wind 412.9 km/s
Aurora 1
Updated 14:00 UTC HamQSL · N0NBH
Day 80/40m Good 30/20m Good 17/15m Fair 12/10m Poor
Night 80/40m Good 30/20m Good 17/15m Fair 12/10m Poor

Callsign Lookup
_
Vanity Call Signs Available
Enter filters above and click Search.
ⓘ Callsign lookups are in real time via the FCC database. Vanity callsign availability is refreshed daily at 6:00 AM CST. The vanity search may be unavailable for a few minutes during this update.
Live DX spots
Live DX Spots — 70cm via PSKReporter · scroll or pinch to zoom
Band
Mode
Time
Loading map data…
MHz DX Spotter Info
Recent spots —
Select a band above to load spots
Ready — select a band to fetch live spots

Choosing a handheld: FT-65R vs ID-52A vs TH-D75 (and where the IC-705 and DMR fit), plus CHIRP, offsets and batteries

ci_cover.jpg

A lot of new-ham HT questions come down to "what should I buy first?" and "why won't it hit the repeater?" Here is a rough framework for discussion, and corrections are welcome. I'm assuming US band plans unless noted. Check your local plan and licensing rules.

Analog FM dual-banders. The Yaesu FT-65R is a straightforward 2 m/70 cm analog FM handheld at roughly 5 W. It has no GPS, no digital modes and no Bluetooth, so there is little to learn and little to break. Budget Baofeng models such as the UV-5R family cost much less and are well supported in CHIRP. The trade-offs are usually receiver selectivity, spurious emissions on some models, menu quirks and variable build quality. For a first radio, many people prefer a known-good analog HT for local repeaters and simplex, then add digital later.

D-STAR handhelds. The Icom ID-52A is a dual-band (2 m/70 cm) D-STAR and analog FM handheld with GPS and Bluetooth. The Kenwood TH-D75 is a tri-band (2 m, 1.25 m, 70 cm) with D-STAR, built-in GPS and APRS. D-STAR needs you to register your callsign with the network before reflector and gateway functions work properly. It is only worth paying for if D-STAR repeaters or reflectors are active in your area, so check local coverage first.

The IC-705. Strictly speaking it isn't an HT. It's a compact portable HF/50 MHz/VHF/UHF all-mode transceiver with D-STAR. Output is about 5 W on its own battery and up to 10 W on external DC. It makes sense as a field or SOTA/POTA-style radio, but it is not a pocket radio. Comparing it with the FT-65R is comparing different tools.

DMR. DMR handhelds from AnyTone, Radioddity, TYT and others are popular and relatively cheap, but they work differently. You need a DMR ID, a codeplug (the channel, talkgroup and contact setup), and some understanding of timeslots and talkgroups. The codeplug is the biggest hurdle. Starting from a well-maintained codeplug for your region is usually easier than building one from scratch.

Antennas and batteries. Stock rubber ducks are a compromise. A better 2 m/70 cm whip, or a roll-up J-pole for a fixed location, often improves performance more than a new radio does. Check the connector first. Many handhelds use SMA-female on the radio, and Baofeng/Kenwood/Yaesu variants are not always the same. Carry a spare battery pack, and consider a battery case that takes AA cells as a backup. Don't leave Li-ion packs fully discharged for long periods.

CHIRP and offsets. CHIRP is free, open-source programming software that supports many models, though not every radio, so check the supported list first. Always download an image from the radio before changing anything, and save the file. Cheap programming cables with unreliable chips cause plenty of "it won't connect" posts. Repeater entries need frequency, duplex direction, offset and CTCSS (PL) tone. In the US, 2 m is usually ±600 kHz and 70 cm is usually ±5 MHz, with 1.25 m typically −1.6 MHz. Other regions differ, for example many European 70 cm repeaters use 7.6 MHz. Always confirm against a current repeater directory or the repeater owner's information.

Emergency use. Programming a radio for emergencies is mostly about preparation: local repeaters, simplex channels, weather channels, and any net frequencies your local group uses. Print a channel list, label your memories clearly, and practice with the radio before you need it. Remember that transmit privileges depend on licensing and radio type. Don't transmit on bands you are not licensed for, and note that GMRS and FRS rules differ from amateur rules.

What would you recommend for a first handheld, and would you start with analog or go straight to digital?

  • Replies 2
  • Views 128
  • Created
  • Last Reply

Top Posters In This Topic

Featured Replies

  • Moderators

For a first radio I'd lean toward a plain analog dual-bander with a good aftermarket antenna. The FT-65R is a reasonable pick because the menus are simple, it covers 2 m and 70 cm, and the manual makes it easy to find out what a function does. You can learn offsets, tones, simplex and repeater etiquette without also learning talkgroups or reflectors.

The Baofeng route can work too, especially if the budget is tight. Buy from a reputable seller, verify CHIRP support for your exact model, and understand that cheap radios can have weaker front ends in crowded RF environments. If you operate near strong transmitters you may notice desense or intermod. That is often worth knowing before you decide a radio is faulty.

On digital, I'd check the local network before buying. A D-STAR or DMR handheld is only useful if you have repeaters, a hotspot, or a group using it. Otherwise it spends most of its time as an analog FM radio.

  • Moderators

Another point on CHIRP: the first thing to do is a clean download from the radio, then save that file as your backup. After that, import repeaters for your area from a current source and spot-check a few against the repeater's own listing. Directory data can be stale, and a wrong offset or tone is the most common reason "the radio hears but can't open the repeater."

If you can receive the repeater output but can't access it, check three things: duplex direction (+ or −), the offset size, and whether it needs a CTCSS tone on transmit. Some repeaters also need a tone on receive for tone squelch, but that's usually optional on your side. Also test on simplex with another ham before blaming the radio. It separates a programming problem from a coverage problem.

For emergency channels, I'd keep a separate memory bank with simple names, such as local simplex, the primary repeater, a backup repeater and weather, and not mix them with a hundred other entries. In a stressful moment, fewer choices are better. Also carry a printed copy of your channel list in case the radio gets reset.

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

Affiliate Disclosure: As an Amazon Associate, Ham Radio Base earns from qualifying purchases. Some links throughout this website may be affiliate links. If you purchase a product through one of these links, we may earn a commission at no additional cost to you. Your support helps us continue creating free articles, tutorials, reviews, and resources for the amateur radio community. N0TLB © Ham Radio Base - Powered by the Ham CQ DX Community. All rights reserved.

Search

Search

Configure browser push notifications

Chrome (Android)
  1. Tap the lock icon next to the address bar.
  2. Tap Permissions → Notifications.
  3. Adjust your preference.
Chrome (Desktop)
  1. Click the padlock icon in the address bar.
  2. Select Site settings.
  3. Find Notifications and adjust your preference.