Planning a dual-band mobile install: FTM-500D vs ID-5100A vs TM-D710G, and how to wire it so it stays quiet
- Replies 2
- Views 50
- Created
- Last Reply
Top Posters In This Topic
-
Mod_Dan 1 post
-
Mod_Chrissy 1 post
I'm planning a first proper 2 m / 70 cm mobile install and have narrowed the choice to three radios: the Yaesu FTM-500D, the Icom ID-5100A and the Kenwood TM-D710G. All three are dual-band mobiles with roughly 50 W on VHF and UHF, so the decision seems to come down to the digital mode or APRS ecosystem, the control head, and how the radio behaves in a vehicle.
My rough understanding is that the FTM-500D is built around System Fusion (C4FM) plus analog FM, the ID-5100A is the D-STAR option with a touchscreen head, and the TM-D710G is the analog-plus-APRS radio with a built-in TNC and GPS support. Please correct me if I've got that wrong.
Beyond the radio choice, I want to get the physical side right the first time. These are the things I'd like input on:
1. Power wiring: where to fuse, what wire gauge to use, and whether to go straight to the battery or to a fuse block.
2. Mounting the body and the control head so nothing is in a knee or airbag zone and the radio still gets airflow.
3. Antenna placement and coax, since I'd like decent performance on both bands from a single dual-band antenna.
4. Chasing alternator whine and ignition or electronics hash before it becomes a permanent annoyance.
5. Cross-band repeat. I'd like to use an HT outside the vehicle through the mobile, and I want to know what to watch for with ID rules, heat and power settings.
6. Mobile operating etiquette, especially on busy repeaters and while driving.
How would you approach it, and what would you check before drilling any holes?
Link to comment
https://www.hamradiobase.com/forums/topic/11014-planning-a-dual-band-mobile-install-ftm-500d-vs-id-5100a-vs-tm-d710g-and-how-to-wire-it-so-it-stays-quiet/Share on other sites