ⓘ Callsign lookups are in real time via the FCC database.
Vanity callsign availability is refreshed daily at 6:00 AM CST.
The vanity search may be unavailable for a few minutes during this update.
Live DX spots
Live DX Spots — 70cmvia PSKReporter · scroll or pinch to zoom
Band
Mode
Time
Loading map data…
MHzDXSpotterInfo
Recent spots—
Select a band above to load spots
Ready — select a band to fetch live spots
Go-kit design for SOTA/POTA: EFHW or linked dipole, which pole, and how to power it?
I'd like to compare notes on how people balance weight, setup time and reliability in a portable kit. The same few decisions come up for most activators, whether the plan is a summit, a state park or a Field Day style site: antenna, support, power and logging. Here is how I'd frame each one, and I'd like to hear where you disagree.
Antenna first. An end-fed half-wave (EFHW) with a 49:1 transformer is popular because it is a single wire, needs no center feedpoint and covers 40/20/15/10 m without a tuner in most builds. The tradeoffs are that the feedpoint impedance is high and varies with height, nearby objects and how the far end is routed. A bit of common-mode current on the coax is normal, so a choke at the radio end helps keep RF out of the shack-in-a-bag. A linked dipole is also simple, but you walk to each link and move it when changing bands. That takes more time, yet it gives a balanced feedpoint and often a more predictable match. If you mostly stay on one or two bands during an activation, links cost little. If you like hopping around for hunters, the EFHW's ease of use is hard to beat.
Support is where many setups go wrong. A telescopic fiberglass pole in the 7 to 10 m range is a common choice, and it works well with an inverted-V or sloping EFHW. Wind is the enemy, so a few guy lines with a simple ring or clip at the right section can stop the top sections from collapsing or whipping. Keep the pole well away from power lines, and never put it up when thunderstorms are anywhere near. Fiberglass does not make you safe from lightning, and a pole in your hand on a ridge is a bad place to be.
For power, a small LiFePO4 pack is the usual answer for QRP to 20 W-ish operation. A 4S LiFePO4 pack is about 12.8 V nominal and runs about 13.3 to 13.6 V when full and rested. That suits most 12 V radios, but check your radio's input range, because some do not like the voltage sag near the end or fuses that are too small. If you add solar, use a controller or charger with a proper LiFePO4 profile, and remember that LiFePO4 cells should not be charged below freezing unless the pack is built for it. On a short activation, a pack sized for the day usually weighs less and is simpler than panels, but solar is handy for multi-day camping or an extended Field Day station.
Logging deserves a plan too. Paper and pencil never run out of battery, and you can type it up later. If you log on a phone or tablet, think about glare, cold-weather battery drain and how you will export to ADIF for the program you are submitting to. Check the current activation requirements for POTA and SOTA before you go, since valid-activation QSO counts and rules differ and can change.
Questions for the thread: what is your pole, and how do you guy it? Do you carry both an EFHW and a linked dipole as a backup? And what is your cutoff for packing up when the weather turns?
I'd like to compare notes on how people balance weight, setup time and reliability in a portable kit. The same few decisions come up for most activators, whether the plan is a summit, a state park or a Field Day style site: antenna, support, power and logging. Here is how I'd frame each one, and I'd like to hear where you disagree.
Antenna first. An end-fed half-wave (EFHW) with a 49:1 transformer is popular because it is a single wire, needs no center feedpoint and covers 40/20/15/10 m without a tuner in most builds. The tradeoffs are that the feedpoint impedance is high and varies with height, nearby objects and how the far end is routed. A bit of common-mode current on the coax is normal, so a choke at the radio end helps keep RF out of the shack-in-a-bag. A linked dipole is also simple, but you walk to each link and move it when changing bands. That takes more time, yet it gives a balanced feedpoint and often a more predictable match. If you mostly stay on one or two bands during an activation, links cost little. If you like hopping around for hunters, the EFHW's ease of use is hard to beat.
Support is where many setups go wrong. A telescopic fiberglass pole in the 7 to 10 m range is a common choice, and it works well with an inverted-V or sloping EFHW. Wind is the enemy, so a few guy lines with a simple ring or clip at the right section can stop the top sections from collapsing or whipping. Keep the pole well away from power lines, and never put it up when thunderstorms are anywhere near. Fiberglass does not make you safe from lightning, and a pole in your hand on a ridge is a bad place to be.
For power, a small LiFePO4 pack is the usual answer for QRP to 20 W-ish operation. A 4S LiFePO4 pack is about 12.8 V nominal and runs about 13.3 to 13.6 V when full and rested. That suits most 12 V radios, but check your radio's input range, because some do not like the voltage sag near the end or fuses that are too small. If you add solar, use a controller or charger with a proper LiFePO4 profile, and remember that LiFePO4 cells should not be charged below freezing unless the pack is built for it. On a short activation, a pack sized for the day usually weighs less and is simpler than panels, but solar is handy for multi-day camping or an extended Field Day station.
Logging deserves a plan too. Paper and pencil never run out of battery, and you can type it up later. If you log on a phone or tablet, think about glare, cold-weather battery drain and how you will export to ADIF for the program you are submitting to. Check the current activation requirements for POTA and SOTA before you go, since valid-activation QSO counts and rules differ and can change.
Questions for the thread: what is your pole, and how do you guy it? Do you carry both an EFHW and a linked dipole as a backup? And what is your cutoff for packing up when the weather turns?
Link to comment
https://www.hamradiobase.com/forums/topic/11029-go-kit-design-for-sotapota-efhw-or-linked-dipole-which-pole-and-how-to-power-it/Share on other sites