Skip to content
View in the app

A better way to browse. Learn more.

Ham Radio Base

A full-screen app on your home screen with push notifications, badges and more.

To install this app on iOS and iPadOS
  1. Tap the Share icon in Safari
  2. Scroll the menu and tap Add to Home Screen.
  3. Tap Add in the top-right corner.
To install this app on Android
  1. Tap the 3-dot menu (⋮) in the top-right corner of the browser.
  2. Tap Add to Home screen or Install app.
  3. Confirm by tapping Install.
Ham Radio Base — Education, Resources, Projects and Community
☀ Solar
SFI 99
SN 26
A 6
K 0 Quiet
X-Ray B2.3
Wind 384.8 km/s
Aurora 1
Updated 13:30 UTC HamQSL · N0NBH
Day 80/40m Good 30/20m Good 17/15m Fair 12/10m Poor
Night 80/40m Good 30/20m Good 17/15m Fair 12/10m Poor

Callsign Lookup
_
Vanity Call Signs Available
Enter filters above and click Search.
ⓘ Callsign lookups are in real time via the FCC database. Vanity callsign availability is refreshed daily at 6:00 AM CST. The vanity search may be unavailable for a few minutes during this update.
Live DX spots
Live DX Spots — 70cm via PSKReporter · scroll or pinch to zoom
Band
Mode
Time
Loading map data…
MHz DX Spotter Info
Recent spots —
Select a band above to load spots
Ready — select a band to fetch live spots

Run vs. S&P, mult timing, and SO2R: how do you decide when to leave a good run frequency?

ci_cover.jpg

I'd like to compare how people make the stay-or-go decision during a contest, because most advice I see is either "always run" or "chase mults." Neither holds up across every contest format.

The basic trade-off is this. Running gives you a steady stream of QSOs, but it's limited by who tunes across you and how well your signal covers the areas you need. Search and pounce (S&P) costs you the frequency and the time spent tuning, but it's the only way to pick up stations who never come to you. In a simple points-times-multipliers contest, one extra multiplier is worth roughly Q/M extra QSOs, where Q is your total QSOs and M is your current multiplier count. That makes mults cheap early, when M is small and a new one is worth only a handful of contacts. Later they get expensive, and you may be better off holding a good run than spending three minutes chasing one station.

That is only the scoring side. The practical side is how you keep an eye on rate. The N1MM rate window helps if you look at short-term rate (last 10 minutes) against the hourly figure. If your 10-minute run rate drops well below what you'd expect to get by tuning, with QSOs and new mults counted together, it may be time to move. If you leave and the S&P pass gives you only a few QSOs, the frequency you left is probably gone too.

Band changes belong in the same discussion. A band change is never free. You lose the run, you lose the frequency, and you may spend several minutes re-establishing on the new band. In contests with per-band multipliers, a well-timed move can still pay for itself. Some multi-operator categories also cap band changes per hour, so check the current rules for the category you're entering rather than relying on memory.

Where do you draw the line between staying and moving? Do you use a fixed rate threshold, or do you go by feel and by what the band is doing?

  • Replies 2
  • Views 42
  • Created
  • Last Reply

Top Posters In This Topic

Featured Replies

  • Moderators

The Q/M figure is a good rule of thumb, but it only works if multipliers are counted the way you assume. In some contests a prefix or section counts once for the whole contest. In others, like CQ WW, zones and countries count again on every band. That changes how you plan. With per-band mults, the second pass on a new band can be worth far more than the first.

One workable approach is to keep the run as your base and go hunting only when a specific station is worth the trip. If a spot shows a rare multiplier on a band where you haven't worked it, jump on it quickly, log it, and go straight back. That's usually cheaper than a long S&P sweep. If you're running low power or have a modest antenna, you might also run less and spend more time pouncing, because a weak run frequency may not give you enough QSOs to justify holding it.

On spotting, rules differ by category. In unassisted classes, many sponsors treat packet spots and Reverse Beacon Network spots as outside assistance. Some also count a local decoder such as CW Skimmer as assistance, and others word it differently. Read the sponsor's definition for that contest. If you enter assisted, set up a spot filter in N1MM for your band and mode and for needed mults, so a busy cluster doesn't bury what you actually want.

  • Administrators

SO2R can make the run-or-pounce question easier, because the second radio becomes your search tool while the first keeps running. The main skill is listening. You can't search effectively on radio 2 if you're half-listening to radio 1. Many operators use headphones with stereo split, so radio 1 is in one ear and radio 2 in the other, and learn to focus on one at a time. The hardware matters too. An SO2R box or controller that handles transmit inhibit, headphone switching and PTT interlock prevents you from keying both radios into the wrong antenna.

Interference between the two radios is the next hurdle. If both are on nearby bands, front-end overload and harmonic or noise problems from the other transmitter can wreck the receive side. Band-pass filters, stubs and physical antenna separation all help, and so does picking band pairs that interfere less. It often makes sense to put your best antenna on the radio that's running and use something smaller on the search radio, though that depends on what you have.

Antennas decide a lot of this. Stacked Yagis let you choose a takeoff angle for the opening, and on 160 and 80 the receiving antenna can matter as much as the transmitting one, because a Beverage or small loop lets you hear stations you'd otherwise miss. If you can't hear well, S&P won't work no matter how clever your logging software is.

For fatigue, plan your off-times before the contest starts rather than deciding when you're tired. The best time to rest is when rate is low on your best bands, and that depends on propagation. Late-night hours on a higher band may produce almost nothing anyway, so you lose little by sleeping then. Poor decisions, missed callsigns and slower exchanges are the early signs that you've been at it too long, and they cost you more QSOs than a planned break would.

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

Affiliate Disclosure: As an Amazon Associate, Ham Radio Base earns from qualifying purchases. Some links throughout this website may be affiliate links. If you purchase a product through one of these links, we may earn a commission at no additional cost to you. Your support helps us continue creating free articles, tutorials, reviews, and resources for the amateur radio community. N0TLB © Ham Radio Base - Powered by the Ham CQ DX Community. All rights reserved.

Search

Search

Configure browser push notifications

Chrome (Android)
  1. Tap the lock icon next to the address bar.
  2. Tap Permissions → Notifications.
  3. Adjust your preference.
Chrome (Desktop)
  1. Click the padlock icon in the address bar.
  2. Select Site settings.
  3. Find Notifications and adjust your preference.