ⓘ Callsign lookups are in real time via the FCC database.
Vanity callsign availability is refreshed daily at 6:00 AM CST.
The vanity search may be unavailable for a few minutes during this update.
Live DX spots
Live DX Spots — 70cmvia PSKReporter · scroll or pinch to zoom
Band
Mode
Time
Loading map data…
MHzDXSpotterInfo
Recent spots—
Select a band above to load spots
Ready — select a band to fetch live spots
Technician to General: how would you split up the 35 Element 3 questions and the HF material?
I'm putting together a study outline for Technicians who want HF privileges and could use a sanity check. Here's what I have so far. Please correct anything that's off or out of date.
Exam basics: Element 3 is 35 multiple-choice questions, and you need 26 correct to pass. A Technician already has Element 2 credit, so Element 3 is the only test for the upgrade. The questions come from a public pool organized into subelements G1 through G0: Commission's rules, operating procedures, propagation, amateur practices, electrical principles, circuit components, practical circuits, signals and emissions, antennas and feed lines, and electrical/RF safety. Pools are replaced on a schedule, so check the NCVEC page or your VE team to confirm which pool your session uses.
How I'd weight the time:
Rules and operating procedures carry a lot of questions and are mostly memorization with some reasoning. This covers sub-band edges, power limits (1500 W PEP in general, 200 W PEP on 30 meters), station ID, third-party traffic, and control operator rules.
Propagation has fewer questions, but it confuses people who haven't operated HF. Focus on the D, E and F layers, MUF versus LUF, solar flux and K/A indices, gray line, and sporadic E.
Electrical principles and components reward knowing the formulas. Cover Ohm's law, power, dB (3 dB is roughly double the power, 10 dB is ten times), reactance, resonance, and RMS versus peak versus PEP.
Antennas and feed lines cover dipole length (about 468/f in MHz gives feet for a half-wave dipole), quarter-wave verticals, SWR, coax loss at HF, baluns and traps.
Digital modes are partly in G8 and partly in G2. Know the difference between dial frequency and audio offset, which sideband is conventional where (LSB below 10 MHz, USB above, and USB on 60 m), and the baud-rate limits on HF.
Band privileges: Technicians already have some CW privileges on 80, 40 and 15 meters and CW/phone/digital on part of 10 meters. General opens up segments of every HF band, but the segments are not the whole band. Phone and CW/data are in different places, and 30 m is CW/data only. I'd tell people to build their own chart from a current band plan rather than memorize someone else's, because writing it out helps the pool questions stick.
Questions for the thread:
Do you teach the pool in order, or by weak area after a baseline practice test?
How much real-world HF listening (an SDR or a remote receiver) is worth doing before the exam?
When should someone start thinking about a vanity call, before or after upgrading?
I'm putting together a study outline for Technicians who want HF privileges and could use a sanity check. Here's what I have so far. Please correct anything that's off or out of date.
Exam basics: Element 3 is 35 multiple-choice questions, and you need 26 correct to pass. A Technician already has Element 2 credit, so Element 3 is the only test for the upgrade. The questions come from a public pool organized into subelements G1 through G0: Commission's rules, operating procedures, propagation, amateur practices, electrical principles, circuit components, practical circuits, signals and emissions, antennas and feed lines, and electrical/RF safety. Pools are replaced on a schedule, so check the NCVEC page or your VE team to confirm which pool your session uses.
How I'd weight the time:
Band privileges: Technicians already have some CW privileges on 80, 40 and 15 meters and CW/phone/digital on part of 10 meters. General opens up segments of every HF band, but the segments are not the whole band. Phone and CW/data are in different places, and 30 m is CW/data only. I'd tell people to build their own chart from a current band plan rather than memorize someone else's, because writing it out helps the pool questions stick.
Questions for the thread:
Link to comment
https://www.hamradiobase.com/forums/topic/11088-technician-to-general-how-would-you-split-up-the-35-element-3-questions-and-the-hf-material/Share on other sites