Lightweight go-kit for POTA and SOTA: EFHW or linked dipole, which pole, and what battery setup?
- Replies 2
- Views 30
- Created
- Last Reply
A better way to browse. Learn more.
A full-screen app on your home screen with push notifications, badges and more.
Let's compare notes on a basic portable HF kit, because the same few decisions come up for every park and summit setup: antenna type, support, power, logging, and how much weather risk you're willing to carry.
For the antenna, the end-fed half-wave (EFHW) is popular because it is quick to deploy. You have one wire, a matching unit (typically a 49:1 transformer), a coax run and one support point. A 40 m-based EFHW is roughly 20 m (about 66 ft) of radiator, and it is also usable on 20, 15 and 10 m because of harmonic resonance. The trade-offs are that it is sensitive to how it's hung (sloper, inverted-L, or flat-top) and to the coax and counterpoise situation. Common-mode current on the feedline is a real thing, so a choke at the feedpoint is worth having.
A linked dipole is the other camp. It is a center-fed dipole with insulated links on each leg, and you connect or disconnect them to change band. It is more fiddly than an EFHW at the start, since you need to keep track of which links are open or closed. The upside is a balanced antenna that tends to behave predictably. It also gives you a clear starting point for trimming each band. The downside is that it needs a center support and enough room for two legs, whereas an EFHW can be stretched along a slope.
For support, a telescopic fiberglass pole in the 6 to 10 m class is the usual choice. Lighter poles are easier to carry but flex and sag with a long wire load, and the bottom sections can collapse if the collar clamps aren't tightened. Guying with thin cord and a few stakes costs little weight and makes a big difference in wind. Keep any wire and pole well away from power lines. If you can't find a safe spot to erect it, skip it.
On power, a small LiFePO4 battery is an easy fit for QRP and 10 to 20 W rigs. The nominal voltage is 12.8 V for a 4S pack, and a full pack sits near 13.3 to 13.6 V at rest, higher on charge. Check your rig's maximum input voltage and whether it behaves at the upper end. Also remember that a BMS usually cuts off suddenly instead of fading out, so you won't get a warning like a lead-acid battery sagging. If you add solar, use a charge controller with a LiFePO4 profile instead of wiring a panel straight to the battery, and don't charge the pack below freezing unless the BMS has low-temperature charge protection.
For logging, a phone or tablet app is convenient, but paper in a zip bag with a pencil is the usual backup when screens fail, batteries die or rain arrives. Remember the activation thresholds: POTA generally requires 10 contacts within a UTC day for a valid activation, and SOTA requires 4 contacts for activation points, and you must be within the summit's activation zone. Always check the current program rules before heading out, since they get updated.
On weather and safety, the simple rule is to decide your turn-around conditions before you leave home. A thunderstorm cell, gusty wind on a ridge, or a fast temperature drop is a reason to take the antenna down early. Tell someone where you're going and when you'll be back, and don't assume you will have cell coverage.
So what are you running as your default portable HF kit, and what do you find fails first in the field: coax, connectors, pole sections, batteries, or the logging workflow?
Link to comment
https://www.hamradiobase.com/forums/topic/11134-lightweight-go-kit-for-pota-and-sota-efhw-or-linked-dipole-which-pole-and-what-battery-setup/Share on other sites