Go-kit design for POTA and SOTA: EFHW or linked dipole, LiFePO4 power, and when to pack it in because of weather
- Replies 2
- Views 24
- Created
- Last Reply
A better way to browse. Learn more.
A full-screen app on your home screen with push notifications, badges and more.
Let's compare notes on how people put together a portable station that is light enough to carry up a hill but still works for a park activation or a Field Day style weekend. Everyone ends up with a different answer, so here are the main decision points. Pick the ones you care about and argue with me.
Antenna: EFHW vs linked dipole. An end-fed half-wave (EFHW) is popular because it is quick to deploy. You need one support point, a feedpoint transformer (commonly 49:1, sometimes 64:1), and a long wire cut for the lowest band. It also works on the harmonics, so a 40 m cut gives you 20, 15 and 10 m without touching anything. The trade-offs are that the feedpoint is high impedance, so common-mode current on the coax can be a real problem. A choke at the feedpoint or at the radio end often helps, along with a short counterpoise wire. Linked dipoles are center-fed and balanced, so they are less fussy about the feedline and ground. The cost is that you have to connect or disconnect links to change band, and you need a decent support at the center.
Supports. A fiberglass telescopic pole of around 10 m (33 ft) is the usual choice for sloper, inverted-V and vertical-ish EFHW layouts. If the pole is going to stand without a tree, bring guy lines and stakes, and plan for where the weight of the wire sits. Telescoping sections can slip, so some people use hose clamps or tape at the joints. If you are going to cut things close, remember that a pole is also a lightning rod and a lever in the wind.
Power. A small LiFePO4 pack is a good match for 100 W-class radios and QRP rigs alike. Nominal voltage is about 12.8 V, which sits in the happy range for most radios rated at 13.8 V. Fuse the positive lead close to the battery, and use polarized connectors such as Anderson Powerpoles so a tired brain at the end of a long day can't reverse it. If you add solar, check that the charge controller has a LiFePO4 profile, because lead-acid profiles do not always suit these cells. Also remember that charging LiFePO4 below freezing can damage cells unless the BMS blocks it. Capacity planning is easier if you estimate the radio's real average current, which is far below its transmit peak on SSB or CW.
Logging. The usual approach is to log on paper or on a phone/tablet app, then export the log in ADIF format afterwards. Paper is the backup that does not run out of battery. Log time in UTC, and record the park or summit reference for each contact. Remember the minimum QSO counts for each program: POTA needs 10 contacts for a valid activation, SOTA needs 4 for activator points. Check the current rules of the program you are working, since they change.
Weather and safety. Decide on your abort criteria before you leave the car. Thunder means taking the antenna down, not finishing the pileup. Keep poles and wires well away from power lines, with a clearance of more than the full height of the pole. Know the temperature drop and exposure risks for your summit, and pack water and layers that matter more than the radio does.
So what is in your go-kit that you would carry again, and what always ends up staying in the car?
Link to comment
https://www.hamradiobase.com/forums/topic/11160-go-kit-design-for-pota-and-sota-efhw-or-linked-dipole-lifepo4-power-and-when-to-pack-it-in-because-of-weather/Share on other sites