Skip to content
View in the app

A better way to browse. Learn more.

Ham Radio Base

A full-screen app on your home screen with push notifications, badges and more.

To install this app on iOS and iPadOS
  1. Tap the Share icon in Safari
  2. Scroll the menu and tap Add to Home Screen.
  3. Tap Add in the top-right corner.
To install this app on Android
  1. Tap the 3-dot menu (⋮) in the top-right corner of the browser.
  2. Tap Add to Home screen or Install app.
  3. Confirm by tapping Install.
Ham Radio Base — Education, Resources, Projects and Community
☀ Solar
SFI 99
SN 26
A 6
K 0 Quiet
X-Ray B2.3
Wind 412.9 km/s
Aurora 1
Updated 14:00 UTC HamQSL · N0NBH
Day 80/40m Good 30/20m Good 17/15m Fair 12/10m Poor
Night 80/40m Good 30/20m Good 17/15m Fair 12/10m Poor

Callsign Lookup
_
Vanity Call Signs Available
Enter filters above and click Search.
ⓘ Callsign lookups are in real time via the FCC database. Vanity callsign availability is refreshed daily at 6:00 AM CST. The vanity search may be unavailable for a few minutes during this update.
Live DX spots
Live DX Spots — 70cm via PSKReporter · scroll or pinch to zoom
Band
Mode
Time
Loading map data…
MHz DX Spotter Info
Recent spots —
Select a band above to load spots
Ready — select a band to fetch live spots

2 m/70 cm antenna choices: J-pole vs slim jim vs 5/8 wave vs yagi, and how much the coax and connectors matter

ci_cover.jpg

I'd like to start a technical thread on VHF/UHF antenna selection, because the same questions come up whether the use is a home base station, a mobile install, a repeater site or a satellite pass. The antenna is only one part of the system. Coax loss, connector choice, polarization and mounting often decide how well a setup works more than a couple of dB of advertised gain.

Start with the simple verticals. A quarter-wave whip is about 19 inches long on 2 m (roughly 234 divided by the frequency in MHz gives feet) and about 6 to 6.5 inches on 70 cm. It needs a ground plane, which on a vehicle is the roof. It has a low-angle, omnidirectional pattern and is mechanically simple. A 5/8 wave whip is taller and, with a matching coil at the base, concentrates more energy toward the horizon. That gives a few dB more at low angles than a quarter-wave over a good ground plane, but it is more dependent on that ground plane, and the gain is less if the ground is poor or the roof is small. On a mag mount, the base couples to the metal body capacitively. It works well on a steel roof but poorly on aluminum, fiberglass or a tiny trunk lid. NMO mounts need a drilled hole, but the result is a solid ground connection and a mount that can take many different whips.

The J-pole and slim jim are both end-fed half-wave verticals. The J-pole uses a quarter-wave matching stub, and the slim jim is a folded variation of the same idea. They are popular because they are cheap to build from ladder line, copper pipe or twin-lead. Their gain is roughly that of a half-wave dipole, and the vertical element is omnidirectional on the horizon. The weak point of both is common-mode current on the feedline. Without a choke or decoupling section just below the feedpoint, the coax shield becomes part of the antenna. That distorts the pattern, can shift the SWR when you move the cable, and sometimes puts RF into the shack. An open-air J-pole with a few turns of coax or a ferrite choke is a different antenna from one with the coax draped against the mast.

Collinear antennas stack phased elements to narrow the elevation pattern. The gain is gained by flattening the beam, not by adding energy. Typical commercial collinears for 2 m or dual-band use give anywhere from about 3 to 9 dBi depending on length. A tall high-gain collinear can be excellent for flat terrain and distant stations. In hilly country or at close range it can send too little signal downhill, so a shorter, lower-gain antenna may work better for local coverage.

Yagis are directional, with typical gains of about 6 to 12 dBi for a practical-size beam. They help with a weak repeater, a distant simplex contact or terrestrial weak-signal work. Polarization matters here. FM voice and repeater work on VHF/UHF is almost always vertical. SSB and CW weak-signal work is conventionally horizontal. Mismatching polarization costs a lot of signal, often 10 to 20 dB or more in practice. For satellite work, linear antennas will see fading as the satellite tumbles or changes orientation relative to you. Circular polarization such as crossed yagis, a turnstile or a helix avoids most of that, but many FM LEO operators get by with a handheld yagi and a handheld or mobile radio, adjusting the antenna angle during the pass.

On the feedline side, coax loss rises quickly with frequency. Approximate figures per 100 ft: RG-58 is around 4.5 dB at 150 MHz and about 8 dB or more at 450 MHz; RG-8X is somewhat better; and low-loss 400-class coax is about 1.5 dB at 150 MHz and about 2.7 dB at 450 MHz. Check the exact datasheet for any cable you buy. A 6 dB gain antenna on 100 ft of RG-58 at UHF can lose most of its advantage to the cable. Connector choice matters too. The PL-259/SO-239 (the 'UHF' connector) is common, cheap and fine on HF and 2 m for modest power. It does not hold a constant impedance and is not weatherproof by design, so it is less appealing on 70 cm and up. The N-type is a constant-impedance, better-sealed connector that is a standard choice for outdoor VHF/UHF, repeater work and anything higher in frequency.

SWR is the last piece that gets misread. It tells you how well the antenna impedance matches the line, not how well the antenna radiates. A dummy load has an excellent SWR and radiates nothing. Lossy coax also improves the SWR you read at the radio, because reflected power gets attenuated on the way back. If possible, measure SWR at the antenna end or with a short test jumper, and then compare it with the reading through the full run. A significant difference points to loss in the cable or a bad connector.

For repeater work, vertical polarization and a good height above average terrain generally matter more than raw gain. Duplexers and antenna spacing handle transmit/receive isolation. For installation in general, keep vertical antennas off to the side of a mast, not directly on top of a metal pole, weatherproof every outdoor connector, use drip loops, and ground the mast and coax properly for lightning protection.

My questions for the thread: which of these tradeoffs have you found most important when choosing between a J-pole, a collinear and a beam? When do you go straight to N-type, and when does it still make sense to use PL-259 on 2 m? And for satellite work, is a handheld Arrow-style yagi enough, or is it worth moving to a fixed circularly polarized setup?

  • Replies 2
  • Views 27
  • Created
  • Last Reply

Top Posters In This Topic

Featured Replies

  • Moderators

One point I'd add on mobile installs: the ground plane matters as much as the antenna. A 5/8 whip on a small mag mount or a mostly fiberglass roof can underperform a plain quarter-wave on a steel roof, because the matching network and the pattern both rely on a decent ground. For a permanent install I'd lean toward NMO in the middle of the roof. If you do use a mag mount, put it centered and clean the surface, and watch where the coax runs. A cable pinched in a door seal can fail in odd ways, including intermittent SWR changes that disappear when you reposition it.

On the SWR point, I'd also check it across the band, not at one frequency. A dual-band whip may match well on one band and poorly on the other if the mount or cable has a problem. A high reading on only one band is a useful clue.

  • Moderators

On the PL-259 question, I'd treat it as a power and frequency compromise, not a hard rule. On 2 m with an HT or a mobile radio, a properly soldered PL-259 will usually be okay. On 70 cm and especially for an outdoor run, I'd choose N-type for the weather sealing and consistent impedance. The worst failures are usually not the connector design but poor soldering, a loose shell or water inside the cable. A sealed jacket on a cheap crimp adapter does not help much if moisture is already getting into the braid.

For satellites, a handheld yagi is a reasonable way to start with FM LEO. The practical trouble is that you must track the satellite, adjust for Doppler on the uplink and downlink, and cope with polarization fading. A fixed turnstile or crossed yagi setup is easier on the operator but gives less gain and may need a preamp or good low-loss cable. I'd choose based on whether you want to learn the pass-tracking skills or want a mostly hands-off station.

For the collinear versus J-pole question, I'd ask about the terrain. If you are on a hill looking down at your coverage area, a very high-gain collinear may be a poor fit, and a simpler antenna could cover the area better.

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

Affiliate Disclosure: As an Amazon Associate, Ham Radio Base earns from qualifying purchases. Some links throughout this website may be affiliate links. If you purchase a product through one of these links, we may earn a commission at no additional cost to you. Your support helps us continue creating free articles, tutorials, reviews, and resources for the amateur radio community. N0TLB © Ham Radio Base - Powered by the Ham CQ DX Community. All rights reserved.

Search

Search

Configure browser push notifications

Chrome (Android)
  1. Tap the lock icon next to the address bar.
  2. Tap Permissions → Notifications.
  3. Adjust your preference.
Chrome (Desktop)
  1. Click the padlock icon in the address bar.
  2. Select Site settings.
  3. Find Notifications and adjust your preference.