Skip to content
View in the app

A better way to browse. Learn more.

Ham Radio Base

A full-screen app on your home screen with push notifications, badges and more.

To install this app on iOS and iPadOS
  1. Tap the Share icon in Safari
  2. Scroll the menu and tap Add to Home Screen.
  3. Tap Add in the top-right corner.
To install this app on Android
  1. Tap the 3-dot menu (⋮) in the top-right corner of the browser.
  2. Tap Add to Home screen or Install app.
  3. Confirm by tapping Install.
Ham Radio Base — Education, Resources, Projects and Community
☀ Solar
SFI 99
SN 26
A 6
K 0 Quiet
X-Ray B2.3
Wind 384.8 km/s
Aurora 1
Updated 13:30 UTC HamQSL · N0NBH
Day 80/40m Good 30/20m Good 17/15m Fair 12/10m Poor
Night 80/40m Good 30/20m Good 17/15m Fair 12/10m Poor

Callsign Lookup
_
Vanity Call Signs Available
Enter filters above and click Search.
ⓘ Callsign lookups are in real time via the FCC database. Vanity callsign availability is refreshed daily at 6:00 AM CST. The vanity search may be unavailable for a few minutes during this update.
Live DX spots
Live DX Spots — 70cm via PSKReporter · scroll or pinch to zoom
Band
Mode
Time
Loading map data…
MHz DX Spotter Info
Recent spots —
Select a band above to load spots
Ready — select a band to fetch live spots

Choosing an HT: FM-only budget radios vs. D-STAR and DMR handhelds, plus the setup basics that matter more than the model

ci_cover.jpg

Handheld pricing runs from very cheap FM-only dual banders to multimode digital radios that cost many times as much, so it's worth sorting out what each tier gets you. This thread is for comparing notes on features, batteries, antennas, programming and emergency use. Corrections and local differences are welcome.

Budget analog dual banders. The Baofeng UV-5R family and the Yaesu FT-65R both cover 2 m and 70 cm FM at about 5 W or less. The Baofengs are very cheap and have a huge accessory ecosystem. The usual complaints are weak receiver selectivity (strong nearby signals can overload it), mediocre transmit spectral purity, and menus that are hard to learn. The FT-65R costs more but is generally seen as a step up in receiver performance and build quality, with a more straightforward interface. Both are analog FM only, which covers most local repeater and simplex activity. Check the current firmware, specs and regulatory status of whatever model you actually buy, because these change between revisions.

D-STAR handhelds. The Icom ID-52A and the Kenwood TH-D75 both do FM and D-STAR digital voice. The ID-52A is a 2 m/70 cm radio with GPS and Bluetooth. The TH-D75 adds 220 MHz coverage in North American versions, with built-in APRS and GPS logging. D-STAR is only useful if there's a D-STAR repeater or reflector you can reach, so look at your area's coverage before paying extra for it. You'll also need to register a callsign for D-STAR, and the radio's call-sign routing settings take some time to understand.

The IC-705 is a different kind of radio. It often shows up in handheld discussions, but it's a portable all-mode transceiver covering HF, 6 m, 2 m and 70 cm, not an HT. It supports SSB, CW and D-STAR, and it makes sense if you want portable HF/QRP work (parks, summits) as well as VHF/UHF. It's bulkier and needs a proper antenna setup, so it doesn't replace a pocketable HT for carrying around or for quick repeater access.

DMR. DMR handhelds from vendors like AnyTone, Radioddity and TYT are popular and relatively inexpensive. They require a DMR ID, a codeplug containing talkgroups, color codes and time slots, and some patience. CHIRP is mainly aimed at analog FM programming. For DMR you'll typically use the manufacturer's CPS or a community firmware tool. Like D-STAR, DMR only pays off if local digital repeaters are active.

Programming with CHIRP. A few habits save trouble. Download the existing configuration from the radio first and save that image file as a backup. Use a decent programming cable, since cheap cables with counterfeit USB chips can cause driver headaches. Import repeater lists from a source like RepeaterBook, then check frequency, offset, tone mode and tone values rather than trusting the import blindly. Use clear names (callsign or location, not just a number), and keep a separate memory block for simplex, weather and emergency channels.

Offsets and tones. In the US, the common conventions are ±600 kHz on 2 m and ±5 MHz on 70 cm, with the direction depending on the sub-band and local coordination. Other countries and regions use different splits (many places use a different 70 cm shift), so always check your local band plan and repeater directory. Many repeaters need a CTCSS tone on transmit; "Tone" encodes only, while "TSQL" also mutes your receiver until the tone is heard. Not every repeater uses the same tone on input and output, so verify both.

Batteries and antennas. Most HTs ship with a single Li-ion pack, and one spare is worth having, especially for event support. If you won't use a pack for weeks, store it partly charged rather than full. Many people find that the stock rubber duck is a major limit on range, and a longer 1/4-wave or 5/8-wave whip often improves things noticeably. Make sure the connector matches (SMA-female vs. SMA-male conventions vary, and some radios use BNC), and avoid transmitting without an antenna attached. For serious range, a roll-up J-pole or small Yagi on a mast beats any rubber duck.

Emergency use. A radio is only helpful if you've set it up beforehand. Program local repeaters, the simplex calling frequencies for your region, NOAA/weather channels where available, and any frequencies your local emergency group uses. Keep a paper copy of the channel list. Remember that a licence is required for amateur transmit, and that wideband receive capability does not mean you may transmit outside the amateur bands. Consider using low power when a nearby station is within range, to save battery.

What would you point a newcomer toward as a first HT, and is paying extra for digital modes worth it for someone who mostly wants local repeater and emergency use?

  • Replies 2
  • Views 26
  • Created
  • Last Reply

Top Posters In This Topic

Featured Replies

  • Moderators

For someone starting out, I'd put the money into a solid analog radio and a better antenna before looking at digital. An FT-65R or a well-regarded budget model covers nearly everything on a local 2 m/70 cm repeater, and you can add a decent whip or a roll-up J-pole for less than the price gap to a D-STAR handheld.

D-STAR and DMR make sense when you've confirmed there's an active digital repeater, hotspot or net you actually want to use. Otherwise you're paying for features you won't touch. The ID-52A and TH-D75 are well-featured radios, but check whether your local group runs D-STAR before choosing between them or a cheaper DMR radio.

On CHIRP, one extra tip: after you import from a repeater database, sort by frequency and look for duplicates or odd offsets. Imported data sometimes includes repeaters that are offline or restricted to members, so trim the list to what you can reach and are allowed to use.

  • Moderators

On the emergency side, I'd stress that keeping the radio simple matters more than the feature count. A short list of channels with clear names, a spare battery, and a way to charge from USB or a 12 V source are worth more than a menu with hundreds of options. Practice swapping to simplex, changing power level and switching to a backup repeater before you need to do it under stress.

It's also worth running a check on your antenna choice. A longer whip can help range, but it also makes the radio awkward to carry and can break at the connector, so a flexible one is often a better pick for a go-bag. If you plan to be on the air for long periods during an event, consider a remote speaker mic and an external antenna on a mast or vehicle, and remember RF exposure guidelines when you're holding a 5 W radio near your face.

Also, double-check that any wideband receive feature you rely on, like weather alerts or airband, actually works the way you expect on your specific model. Spec sheets and regional versions don't always match.

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

Affiliate Disclosure: As an Amazon Associate, Ham Radio Base earns from qualifying purchases. Some links throughout this website may be affiliate links. If you purchase a product through one of these links, we may earn a commission at no additional cost to you. Your support helps us continue creating free articles, tutorials, reviews, and resources for the amateur radio community. N0TLB © Ham Radio Base - Powered by the Ham CQ DX Community. All rights reserved.

Search

Search

Configure browser push notifications

Chrome (Android)
  1. Tap the lock icon next to the address bar.
  2. Tap Permissions → Notifications.
  3. Adjust your preference.
Chrome (Desktop)
  1. Click the padlock icon in the address bar.
  2. Select Site settings.
  3. Find Notifications and adjust your preference.