Getting started on LEO satellites: FM birds vs. linear transponders, Doppler, and what antenna setup makes sense
- Replies 2
- Views 30
- Created
- Last Reply
A better way to browse. Learn more.
A full-screen app on your home screen with push notifications, badges and more.
Starting a thread to collect practical advice on satellite operating, since the topic covers a lot of ground and newcomers often don't know where to begin. Corrections are welcome, and so are additions from people who run different setups.
The first split is FM satellites versus linear transponders. FM birds like SO-50 and the AO-91/AO-92 family behave like a repeater in the sky. They are single-channel, so only one station at a time can use them, and you work through them with an HT or mobile. The ISS can do the same job when its crossband voice repeater is switched on, and it also carries an APRS digipeater on 145.825 MHz. Operating status for all of these changes. Some satellites go into eclipse-limited schedules and others go silent for long periods, so check the AMSAT status pages and the current frequency and CTCSS tone information before you plan a pass. Don't trust an old frequency chart.
Linear transponders such as RS-44 are a different experience. The transponder takes a whole slice of spectrum and retransmits it, so many SSB and CW stations can use it at once. RS-44 is an inverting transponder: if you move your uplink up in frequency, the downlink moves down. That helps with Doppler management, but it can be confusing at first. SSB usually needs better frequency discipline than FM does, because a few kHz of error makes the other station sound like Donald Duck.
On Doppler shift: for typical LEO orbits the shift is roughly up to about 10 kHz either side of nominal on 70 cm and about a third of that on 2 m. It is zero at closest approach and swings sign as the satellite passes overhead. On FM you either step the radio's memory channels through the pass or let software do it. On linear birds, many operators fix their own uplink and tune the downlink, or let rig control handle both ends. Gpredict and SatPC32 can both drive compatible radios through CAT, and both predict AOS, LOS and max elevation. They differ in how much setup the radio interface needs.
For antennas, a handheld dual-band Arrow-style 3-element Yagi and an HT is the usual starting point for FM passes. For linear work, a pair of crossed Yagis (circular) or a pair of linear Yagis plus an az/el rotator is common. If you only use a handheld Yagi, you steer it by hand and keep it pointed at the satellite. Polarization fading is a real thing, and you can sometimes rotate the antenna slightly to stabilize the signal. For fixed-azimuth listening a turnstile or an Eggbeater is also popular.
A couple of questions to start the discussion:
Link to comment
https://www.hamradiobase.com/forums/topic/11320-getting-started-on-leo-satellites-fm-birds-vs-linear-transponders-doppler-and-what-antenna-setup-makes-sense/Share on other sites