Building a Layered Go-Kit: HT, Mobile, Power, Antennas and a Family Plan That Doesn't Depend on Ham Licenses
- Replies 2
- Views 24
- Created
- Last Reply
A better way to browse. Learn more.
A full-screen app on your home screen with push notifications, badges and more.
Let's put together a practical readiness checklist for hams. Most of us have a pile of radio gear. Far fewer of us have a kit that works when the lights are out, the cell network is jammed, and the family is split across town. This thread is meant for comparing approaches, so tell me what you'd change.
Start with the mission, not the gear. A go-kit for a served-agency deployment looks different from a home-shelter kit, and both differ from a car kit that just needs to get you a weather report and a check-in. Pick one or two scenarios, such as a multi-day power outage or a regional storm with a road closure, and build around them. A kit with no defined purpose tends to end up heavy and incomplete.
HT kit. The core is the handheld, a spare battery or a battery case for AA cells, a charger that works from 12 V as well as from the wall, and a better antenna than the stock rubber duck. A flexible whip or a roll-up J-pole on a rope can noticeably improve your reach to a repeater. Add a paper list of local repeaters with offsets and CTCSS tones, plus simplex frequencies. Don't rely on programming alone. Radios get reset, and phones die. Programming a few channels for NOAA weather, FRS, GMRS (if licensed) and MURS lets you hear what the rest of your household and neighborhood may be using, though you should only transmit where you're authorized.
Mobile kit. A 2 m/70 cm mobile in the vehicle gives you more power and a proper antenna. Fuse the power lead as close to the battery as you can, and use a connector standard you'll actually keep consistent across the kit. Anderson Powerpoles are the usual choice because they let you swap between a battery, a supply and a vehicle without rewiring. Keep a magnetic-mount or temporary antenna in the kit in case the permanent one is damaged. Check SWR before you need it.
Backup power. Size your battery from what you actually draw. An HT on receive pulls very little. A 50 W mobile transmitting at full power pulls a lot, but only while you're keyed up, so duty cycle matters. A LiFePO4 battery is a popular choice because it's lighter and tolerates deep discharge better than lead-acid, but a sealed AGM battery is still a reasonable budget option. Whatever you choose, test the whole chain: battery, fuse, cable, radio, and charger.
Solar. A panel should go through a charge controller to the battery. Don't connect it straight to the battery and hope for the best. Compare the panel's rated output to your daily consumption, then assume you'll see less than the label in real conditions: clouds, angle, heat and shade all cut output. Folding panels are easier to deploy, but check their connector and voltage compatibility with your controller before relying on them.
Antennas. A basic antenna kit might include a coax jumper, a mast or telescoping pole, a rope and a few stakes, plus a dual-band J-pole or a ground-plane. For HF, a simple wire dipole cut for a band you can use at the distances you care about, such as 40 m or 80 m for regional contacts, is cheap and effective. Pack a small SWR/antenna analyzer if you can, and pre-cut and label everything.
GMRS, FRS and MURS. These services matter because family members who aren't hams can use them. FRS requires no license, though it has power and equipment limits. GMRS needs an FCC license in the US, but a single license covers the licensee's immediate family. It allows higher power and repeater use. MURS is license-free on five VHF channels, with its own power and equipment rules. Read the current FCC Part 95 rules for the details of each service, as they've changed over the years. Treat range claims on blister packs with skepticism, because terrain and buildings often cut that range by a lot.
Weather radio. A NOAA Weather Radio receiver with SAME alerting and battery backup gives you warnings without a network. Check that it's set for your county code and keep spare batteries with it. Many hams also have scanners or radios that receive the weather channels, which is a useful backup but not a substitute for a dedicated alert radio that sounds an alarm.
Family communication plan. Decide in advance how you'll try to reach each other: text first (it often gets through when voice calls don't), then an out-of-area contact everyone can check in with, then a radio schedule. Choose a rally point near home and another farther away. Write the plan on a card for each person, including your simplex channel and a fixed check-in time (for example, at the top of the hour). Practice it before you need it.
First aid and supplies. A kit should cover the things you're trained to use: bandages, gauze, tape, gloves, any personal medications, and so on. If you carry a tourniquet or similar item, get proper training. Add water, food, a flashlight or headlamp, spare batteries, a notepad with pencils (they work when pens freeze), a paper map and a battery or hand-crank phone charger. Rotate perishable items on a schedule.
Grid-down plan. Decide who monitors what, and when. Conserving power by listening more and transmitting less is a good rule. Know your local ARES/RACES or club net information in advance, and learn how your served agencies expect to be contacted, since a checklist is no good if you've never met the net control operator. And remember that during an actual emergency, priority traffic and emergency calls take precedence over casual chatter.
What's in your kit that you'd call essential, and what looks good on a list but isn't worth the weight?
Link to comment
https://www.hamradiobase.com/forums/topic/11417-building-a-layered-go-kit-ht-mobile-power-antennas-and-a-family-plan-that-doesnt-depend-on-ham-licenses/Share on other sites