Skip to content
View in the app

A better way to browse. Learn more.

Ham Radio Base

A full-screen app on your home screen with push notifications, badges and more.

To install this app on iOS and iPadOS
  1. Tap the Share icon in Safari
  2. Scroll the menu and tap Add to Home Screen.
  3. Tap Add in the top-right corner.
To install this app on Android
  1. Tap the 3-dot menu (⋮) in the top-right corner of the browser.
  2. Tap Add to Home screen or Install app.
  3. Confirm by tapping Install.
Ham Radio Base — Education, Resources, Projects and Community
☀ Solar
SFI 99
SN 26
A 6
K 0 Quiet
X-Ray B2.3
Wind 384.8 km/s
Aurora 1
Updated 13:30 UTC HamQSL · N0NBH
Day 80/40m Good 30/20m Good 17/15m Fair 12/10m Poor
Night 80/40m Good 30/20m Good 17/15m Fair 12/10m Poor

Callsign Lookup
_
Vanity Call Signs Available
Enter filters above and click Search.
ⓘ Callsign lookups are in real time via the FCC database. Vanity callsign availability is refreshed daily at 6:00 AM CST. The vanity search may be unavailable for a few minutes during this update.
Live DX spots
Live DX Spots — 70cm via PSKReporter · scroll or pinch to zoom
Band
Mode
Time
Loading map data…
MHz DX Spotter Info
Recent spots —
Select a band above to load spots
Ready — select a band to fetch live spots

Go-kit philosophy for SOTA/POTA: what's actually worth carrying, and what's just weight?

ci_cover.jpg

Thought this would make a good thread, since field setups seem to split into two camps: the people who strip everything down to a QRP rig, a wire and a pole, and the people who build a small portable station that happens to fit in a pack. Neither is wrong, but the trade-offs are worth talking through.

Here's a rough framework for the pieces most kits are built from.

Antenna and support: an end-fed half-wave (EFHW) on a telescopic pole is the default for a lot of activators because it's one wire, one feedpoint and quick to deploy. The usual 49:1 or 64:1 transformer is there to bring the very high feedpoint impedance down to something a rig can load. Because it's end-fed, the coax shield and the radio itself often act as part of the antenna, so a short counterpoise and a choke at the feedpoint can make a noticeable difference to SWR stability and noise. A linked dipole is the other common choice. It's center-fed, has a more predictable pattern and tends to be less sensitive to what's around the feedpoint, but you have to handle the links, and band changes mean either walking out to the wire or lowering the mast.

Power: LiFePO4 has become popular because the nominal 12.8 V (4S) sits close to what 12 V radios expect, the weight is reasonable, and the discharge curve is flat. Check your radio's upper voltage limit against the pack's full-charge voltage, which is typically around 14.4 to 14.6 V for a 4S pack. Also don't charge LiFePO4 below freezing unless the pack has low-temperature protection. If you add a solar panel, put a proper charge controller with a LiFePO4 profile between the panel and the battery rather than wiring them together directly.

Logging: paper is still the most reliable option when it's cold, raining or your phone is at 8%. If you log digitally, make sure the software works offline, record UTC time, and write down the park or summit reference on every page so transcription later isn't guesswork. Many people log on paper and enter it into ADIF later, which also helps you catch busts.

Safety and weather: a metal telescopic pole is a lightning rod. If storms are forecast, or building as you operate, the right plan is to be down early, not to push for one more QSO. Wind loading on a tall pole is the other common issue, so guy lines and a plan for dropping it quickly are worth the few grams.

So, what does your minimum viable kit look like? What do you always bring that someone else would call overkill, and what have you stopped carrying because it never got used?

  • Replies 2
  • Views 33
  • Created
  • Last Reply

Top Posters In This Topic

Featured Replies

  • Administrators

One way to decide what stays in the pack is to split items into "operation fails without it" and "operation is nicer with it." In the first group: rig, a power source with margin, an antenna and something to hold it up, a feedline, a key or mic, headphones, pen and paper. Spare fuses and a couple of connector adapters probably belong there too, because one dead connector can end the whole outing. Everything else is comfort, and comfort is fine, but it should be a conscious choice rather than gradual creep.

On EFHWs, if you see an unexpectedly high or drifting SWR, check the feedpoint environment first. Coax laid across wet ground, a coax run that happens to be near a resonant length, or your hand on the transformer can all move things around. Rerouting or coiling the feedline, adding a choke, or changing the counterpoise length is often cheaper than assuming the antenna is faulty. A short dedicated counterpoise isn't cheating, it's part of the design.

For power, size the battery to the activation, not to your worst-case imagination. SSB at 10 W draws very different current from CW at 5 W, and receive current adds up over a long session. A simple capacity estimate (average amps × hours, plus margin) tells you more than the label on the battery.

  • Moderators

Adding the group-operation angle, because Field Day-style setups put different pressure on the same decisions. With several stations on site, antenna separation, band filters and cable management matter more than weight. A transmitter on 20 m close to a receiver on 15 m can wipe out the neighbor's audio even when both are working perfectly in isolation. Bandpass filters and sensible antenna placement help far more than turning the power down.

Power distribution is where group setups most often go wrong. A properly fused distribution block with a fuse per rig, adequate wire gauge, and labeled leads is boring but saves a lot of confusion when something trips at 2 a.m. LiFePO4 can supply very high current into a short, so fuse close to the battery terminal, not just at the radio.

On logging, shared logging software on a local network is great until the Wi-Fi hiccups. Agree on a backup in advance: paper sheets per station, a clear rule on who is the master log, and a periodic export. Duplicate checking and clean ADIF export are much easier to sort out before the event than after it.

For weather, treat it as part of the operating plan. Decide in advance who watches the sky, what the threshold is for shutting down, and where people go. Disconnecting antennas from the radios and lowering masts takes time, so start before you need to.

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

Affiliate Disclosure: As an Amazon Associate, Ham Radio Base earns from qualifying purchases. Some links throughout this website may be affiliate links. If you purchase a product through one of these links, we may earn a commission at no additional cost to you. Your support helps us continue creating free articles, tutorials, reviews, and resources for the amateur radio community. N0TLB © Ham Radio Base - Powered by the Ham CQ DX Community. All rights reserved.

Search

Search

Configure browser push notifications

Chrome (Android)
  1. Tap the lock icon next to the address bar.
  2. Tap Permissions → Notifications.
  3. Adjust your preference.
Chrome (Desktop)
  1. Click the padlock icon in the address bar.
  2. Select Site settings.
  3. Find Notifications and adjust your preference.