Skip to content
View in the app

A better way to browse. Learn more.

Ham Radio Base

A full-screen app on your home screen with push notifications, badges and more.

To install this app on iOS and iPadOS
  1. Tap the Share icon in Safari
  2. Scroll the menu and tap Add to Home Screen.
  3. Tap Add in the top-right corner.
To install this app on Android
  1. Tap the 3-dot menu (⋮) in the top-right corner of the browser.
  2. Tap Add to Home screen or Install app.
  3. Confirm by tapping Install.
Ham Radio Base — Education, Resources, Projects and Community
☀ Solar
SFI 99
SN 26
A 6
K 0 Quiet
X-Ray B2.3
Wind 384.8 km/s
Aurora 1
Updated 13:30 UTC HamQSL · N0NBH
Day 80/40m Good 30/20m Good 17/15m Fair 12/10m Poor
Night 80/40m Good 30/20m Good 17/15m Fair 12/10m Poor

Callsign Lookup
_
Vanity Call Signs Available
Enter filters above and click Search.
ⓘ Callsign lookups are in real time via the FCC database. Vanity callsign availability is refreshed daily at 6:00 AM CST. The vanity search may be unavailable for a few minutes during this update.
Live DX spots
Live DX Spots — 70cm via PSKReporter · scroll or pinch to zoom
Band
Mode
Time
Loading map data…
MHz DX Spotter Info
Recent spots —
Select a band above to load spots
Ready — select a band to fetch live spots

Run, S&P, or hop bands? How do you decide when a multiplier is worth the rate hit (and where SO2R fits)

ci_cover.jpg

Most contest operating advice boils down to "keep the rate up and pick up multipliers", but those two goals pull against each other constantly. I'd like to compare how people actually make the decision in the chair, so here is a framework to argue with.

Start with the marginal value of each contact. In a typical QSO-points-times-multipliers contest, score = points × mults. One more QSO adds roughly (average points per QSO × current mults). One more new multiplier adds roughly (total QSO points so far). If every QSO is worth 1 point, a new mult is worth about Q/M contacts. With 1,000 QSOs and 100 mults, a new mult equals about 10 contacts. With 300 QSOs and 60 mults, it equals about 5. Early in a contest the QSO count is small, so mults are cheap to ignore. Later the mult is worth chasing, but only if you can get it in less time than it would take to make that many QSOs at your current rate. If your run rate is 120/hr, 10 QSOs is five minutes. A 30-second tune, call and exchange is a bargain. A 10-minute pileup fight for a rare one is not.

That is the core of search-and-pounce versus running. Running at a steady rate usually beats S&P on raw QSOs per hour, because you don't spend time tuning, listening and waiting for the other station to finish. S&P is how you collect mults that never come to you, and it is often the better choice when the run frequency is dead, when the band is closing, or when you have no clean frequency. The cleanest compromise is to run until the rate falls below a threshold, then do a short S&P sweep through the band map for needed mults, then go back to CQing. N1MM Logger+'s rate display, the available-mults/Qs window and the band map make that threshold easy to watch. What do you use as a trigger? A fixed number like 60/hr, a drop against your last 10-minute rate, or just a gut feeling?

Band changes have their own cost. Each one means a few seconds to retune and re-establish a run frequency, then a ramp-up while people find you. The usual logic is to change when the next band is better, not because the current one has "gone quiet" for a few minutes. Look at your 10- and 60-minute rate by band, check the band map, and think about propagation timing: grayline openings, the 15/10 meter closing in the afternoon, and the low bands opening toward dusk. Many people use the first 10-20 minutes after a band change as a diagnostic. If the rate doesn't come up, they go back or try another band.

SO2R changes the arithmetic. With two radios and a way to switch audio and keying, you can run on one radio while the second searches for mults. The second radio only needs a few seconds to snag one, and you only lose rate if the second radio takes your attention away from the run. SO2R is not free, though. It needs a hardware interface or a supported switch, band-pass filters or stubs to limit the interference between radios, good headphone audio (many operators use stereo split so each radio goes to one ear), and some thought about antenna separation and band pairings. Adjacent bands, or a harmonic pair like 40 and 20, are harder than 20 and 80. There is also a human limit. The extra radio is only helpful if you can manage it without sloppy copy and logging errors.

On the data side, spots are a big lever. A skimmer or packet/RBN spots can show where the mults are without tuning. Remember the rules: in many contests, using spotting information from outside your own station puts you in an Assisted class, while Unassisted categories restrict that. Check the rules for each contest, including how they treat local decoders, before deciding what to have running. Assisted vs. Unassisted, power level (high, low, QRP), single band vs. all band, and the contest's treatment of two radios can all change your best strategy. For example, with spots available you can spend more of your time running, because mults can be targeted exactly when you want them.

Finally, there are antennas and endurance. Gain is nice, but being able to switch quickly between a stack, a single higher Yagi, and a low-angle option may matter more than a few dB of gain on one band. On 160/80/40, a good receive antenna (Beverage, loop or other low-noise option) often helps more than extra power. And in a 24- or 48-hour contest, rate over the whole event depends on staying sharp. Hydration, food, planned breaks and when you take your off time are all strategy. A popular method is to look at the rate sheet and put your off time where your rate normally drops anyway, rather than guessing.

Questions for the thread: How do you set your S&P trigger? What is your rule for leaving a band that is still giving moderate rate? If you use SO2R, which band pairings work, and which fail because of interference? And how do you plan breaks so you don't lose a prime opening?

  • Replies 2
  • Views 26
  • Created
  • Last Reply

Top Posters In This Topic

Featured Replies

  • Moderators

The Q/M rule of thumb is useful, but keep an eye on the effective value of mults by band. In contests where mults count per band (CQ WW style), a mult on 10 meters is a separate chance from the same mult on 20, so it can be worth waiting for the band to open and then taking a quick swing. In contests where each mult counts once, a rare mult is worth less after you've worked it elsewhere. The "worth 10 QSOs" figure gets worse as your QSO total grows, which is why the typical advice is to stop chasing each one in the final hours unless it takes under a minute.

For the trigger, I would not rely on a single fixed rate. A drop against your own rate on that band is more telling. If the current band gives 90/hr but the previous hour on a comparable band was 140/hr, that is a nudge to move. If you are hearing your own CQs returned slowly while the band map shows a lot of unworked mults, that is a nudge toward S&P. N1MM makes this easy because you can watch the rate window and the available-mults list at the same time.

On SO2R, the less glamorous part is the discipline: sticking to a routine for what the second radio does. A common one is to keep the second radio on the next-best band, tuned to the band map's best mult, and only touch it when the run radio is between callers. Then, when the run radio has someone calling, don't leave it just to finish a second-radio contact. Prioritizing the running contact is where the rate comes from.

  • Moderators

One point not to skip is that categories shape strategy more than people expect. Assisted operating lets you use spots to take quick mults, so running with spots often favors a steadier "run plus short mult runs" pattern. In an unassisted category you have to find mults yourself, so more of the time goes to tuning the band, and that makes SO2R's second receiver more valuable for finding stations. Also check whether a contest has a separate category for two radios. Some do not, which means you are competing in the same class as single-radio operators, while some multi-operator classes bring different rules on transmitters.

Regarding interference, the best fix is separating the problem, not just throwing a filter at it. Look at harmonic relationships (40 and 15 are close in ways that matter), the physical distance and polarization between antennas, and whether your receiver front ends overload from a nearby transmitter. A band-pass filter at the radio helps with out-of-band energy, while stubs or antenna spacing address in-band overload. If you can only afford one improvement, test pairs of bands at low power first, listening for key clicks or noise rising on the other radio, before the contest.

For fatigue, rather than just "sleep when it's slow", think of two decisions: the length of your off-time block and when you place it. A single longer block can be better than many short naps if the break comes at a time when your rate is lowest, but you also need to leave enough time to catch the evening openings on the low bands. If you have a plan for meals and water ahead of time, those decisions are no longer something you have to make while the rate is high.

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

Affiliate Disclosure: As an Amazon Associate, Ham Radio Base earns from qualifying purchases. Some links throughout this website may be affiliate links. If you purchase a product through one of these links, we may earn a commission at no additional cost to you. Your support helps us continue creating free articles, tutorials, reviews, and resources for the amateur radio community. N0TLB © Ham Radio Base - Powered by the Ham CQ DX Community. All rights reserved.

Search

Search

Configure browser push notifications

Chrome (Android)
  1. Tap the lock icon next to the address bar.
  2. Tap Permissions → Notifications.
  3. Adjust your preference.
Chrome (Desktop)
  1. Click the padlock icon in the address bar.
  2. Select Site settings.
  3. Find Notifications and adjust your preference.