Getting from 5 to 20 WPM: plateaus, head copy, drills, and when to start making contacts
- Replies 2
- Views 28
- Created
- Last Reply
Top Posters In This Topic
-
Mod_Dan 1 post
-
Mod_Chrissy 1 post
A better way to browse. Learn more.
A full-screen app on your home screen with push notifications, badges and more.
This thread is for pooling practical advice on building CW speed from beginner level (about 5 WPM) to a comfortable 20. Most people hit the same walls along the way, so here is a rough map of the stages. Correct it or add to it.
Stage 1: 5 to 10 WPM. The main job is learning characters as sounds, not as dots and dashes you have to count. Most training advice says to send characters at a fast rate, around 18 to 20 WPM, and stretch the gaps between them. This is Farnsworth spacing. The Koch method works the same way: start with two characters at full speed and add one at a time once you copy about 90 percent of the current set. Both approaches try to keep you from learning a slow, count-the-elements rhythm that you later have to unlearn.
Stage 2: 10 to 15 WPM, the usual plateau. This is where many learners stall. Copying letter by letter with a pencil starts to fall behind the incoming code. The fix is usually to stop translating each letter and begin hearing common words and letter groups as units, such as THE, AND, ING, and your own callsign. Raising the gap-free speed while keeping the character speed fixed is one way to push through. Another is to mix in short words and callsign drills so your brain has something bigger than a letter to latch onto.
Stage 3: 15 to 20 WPM and head copy. At some point writing every letter becomes the bottleneck. Head copy means following the content without writing it down. A common way in is to put the pencil down for easy material, such as calls and signal reports, and keep it for names and QTHs. Over time, extend the stretch you hold in your head.
Questions I'd like the thread to cover:
Link to comment
https://www.hamradiobase.com/forums/topic/11528-getting-from-5-to-20-wpm-plateaus-head-copy-drills-and-when-to-start-making-contacts/Share on other sites