Building a ham go-kit that actually works: what to pack, what to test, and where GMRS/MURS/FRS fit
- Replies 2
- Views 26
- Created
- Last Reply
A better way to browse. Learn more.
A full-screen app on your home screen with push notifications, badges and more.
Let's start a thread on go-kit and readiness planning. Many kits get built once, put in a closet, and never turned on until the day they're needed. Below is a framework to argue with, add to, or tear apart.
1. Define the job before you buy gear. A kit for a 72-hour evacuation is different from one for a long power outage at home, and both differ from a kit for serving as a volunteer with a local emergency communications group. Decide which of these you are building for: (a) getting your family in touch with each other, (b) receiving information, (c) helping a served agency or net. Most people need (a) and (b) first.
2. HT kit (the grab-and-go layer). A dual-band handheld, a spare battery or an AA battery case, a charger that works from 12 V and USB, and a better antenna than the stock rubber duck, such as a roll-up J-pole or a telescoping whip. Add a programming cable and a printed channel list. Keep a laminated card with local repeaters, simplex frequencies (146.520 and 446.000 MHz are the common national calling frequencies), and your family's agreed channels. Don't rely on a phone app for your only copy of the frequency list.
3. Mobile/base layer. A 25-50 W mobile rig can run from the vehicle or from a battery. A 50 W transmit can pull roughly 10-12 A at 13.8 V, so wire gauge, fusing, and connectors matter. Anderson Powerpoles are the common standard in ham circles because they make gear interchangeable. Fuse close to the battery, and carry spare fuses.
4. Power. A deep-cycle or LiFePO4 battery of around 20-50 Ah is a common size for a radio-only kit. The numbers: average draw times hours of use equals amp-hours needed, and a radio receiving most of the time uses far less than one transmitting. If you add solar, use a charge controller rather than connecting a panel directly to a battery. Test the panel in real shade and weak sun, not just on a bright day. Keep a power bank for HTs and phones, and top off stored batteries on a calendar.
5. Antenna kit. Include coax with a known good SWR, a mag mount, a roll-up J-pole or similar, a length of paracord, and something to hang it from. For HF, a pre-cut wire dipole or end-fed on a lightweight mast or tree-launch line can be enough. Pre-tune and label everything. A tangle of unknown coax in a bag is not a kit.
6. Receive-only information. A NOAA weather radio with SAME alerts (the 162.400-162.550 MHz band) and a battery or hand-crank option is cheap and tells you what is coming. Many HTs and scanners can also monitor weather channels, but a dedicated unit can sit alerting for you.
7. GMRS, MURS, and FRS. These are useful for family and neighborhood comms where not everyone holds a ham license. FRS needs no license in the US. GMRS requires an FCC license, which covers the licensee's immediate family, and permits more power and repeaters. MURS is a license-free VHF service with five channels and a low power limit. Short range is the common limit with all three, so set expectations: a few blocks to a few miles depending on terrain. Verify current FCC rules and your radio's certification before relying on any of them.
8. Family communication plan. Pick an out-of-area contact, two meeting points (near home and farther away), and scheduled check-in times, for example on the hour at set minutes, so batteries aren't wasted on constant listening. Write down who has which radio and on which channel. Texts often get through when voice calls don't, but have a radio fallback.
9. First aid and supplies. A radio kit is not a survival plan alone. Pack a first aid kit sized to your family, any prescription backups, water and water treatment, a headlamp with spare batteries, a notepad and pencils (logging matters), gloves, a multitool, and copies of your license and key documents. Rotate food, batteries, and medications on a schedule.
10. Test it. Run a field day style test: set up the whole kit from the bag, key up a repeater, and work a simplex check-in with a friend. Time yourself. Whatever slowed you down is your next fix.
One note on etiquette: in a real emergency, don't self-deploy to an incident. Check in with your local net or the group you volunteer with and follow their direction. Keep emergency frequencies clear for traffic that needs them.
What is in your bag that most people forget, and what do you keep out of it?
Link to comment
https://www.hamradiobase.com/forums/topic/11578-building-a-ham-go-kit-that-actually-works-what-to-pack-what-to-test-and-where-gmrsmursfrs-fit/Share on other sites