ⓘ Callsign lookups are in real time via the FCC database.
Vanity callsign availability is refreshed daily at 6:00 AM CST.
The vanity search may be unavailable for a few minutes during this update.
Live DX spots
Live DX Spots — 70cmvia PSKReporter · scroll or pinch to zoom
Band
Mode
Time
Loading map data…
MHzDXSpotterInfo
Recent spots—
Select a band above to load spots
Ready — select a band to fetch live spots
How do you decide if a band is really open? SFI, K index, VOACAP, WSPR and beacons compared
Propagation advice tends to fall into two camps: look at the numbers (SFI, A, K, sunspots), or just turn on the radio and listen. Both approaches have blind spots, so I'd like to hear how people combine them in practice.
Here is how I understand the numbers. The 10.7 cm solar flux (SFI) is a proxy for the ionizing radiation that builds the F layer. Higher flux generally means a higher MUF, so 15, 12 and 10 meters are more likely to support F2 paths. But SFI is a single daily snapshot. It says nothing about your path, the time of day, or whether the D layer is eating your signal. The sunspot number follows the roughly 11-year cycle and is better for long-term expectations than for tonight's operating decisions.
The A index is a daily average of geomagnetic activity, and the K index is a 0 to 9 measure for each three-hour period. Quiet conditions (low A, K of 0 to 2) usually favor stable HF paths. A rising K, especially on paths crossing high latitudes, often brings flutter, absorption or a depressed MUF. The Kp value is a planetary average, though, so a local K can differ from it. A strong flare can also cause a sudden daytime radio blackout on the sunlit side of the Earth, even when the A and K values look fine.
Then there is layer behavior. In daylight the D layer absorbs lower HF, which is why 160, 80 and 40 meters are poor for longer paths at midday but improve around sunset and at night. The F layer, and F2 in particular, carries the long-distance work on the higher bands. Gray line paths work because the D layer is fading or has not yet formed along the terminator, while the F layer is still supporting propagation.
Beyond the F layer there are the "other" modes. Sporadic E can bring short-skip openings on 10 meters and 6 meters, and occasionally higher, with a strong seasonal pattern in mid-latitudes. Tropospheric ducting on VHF and UHF depends on temperature inversions and weather patterns rather than solar numbers. NVIS is the opposite use case: high-angle signals on a frequency below the critical frequency, which fills in regional coverage when the skip zone would otherwise leave gaps.
For checking in real time, I see these tools used most:
VOACAP-based predictors for planning. They give monthly median expectations by path, power, antenna and time, which is good for deciding where to point and when to call CQ, but not a live report.
WSPR and PSK Reporter-style spots to see where low-power signals are actually being decoded right now.
The Reverse Beacon Network for CW and RTTY activity, when you want to see who is hearing whom.
The NCDXF/IARU beacons near 14.100, 18.110, 21.150, 24.930 and 28.200 MHz. Each of the 18 beacons transmits in turn in a three-minute cycle, stepping down in power, so you can quickly tell which regions are audible and how strong.
My questions: when the indices and the live data disagree, which do you trust? Do you have a routine for a quick band check before you commit to an operating session? And how do you treat WSPR spots given that they are low power, narrow bandwidth and station-dependent?
Propagation advice tends to fall into two camps: look at the numbers (SFI, A, K, sunspots), or just turn on the radio and listen. Both approaches have blind spots, so I'd like to hear how people combine them in practice.
Here is how I understand the numbers. The 10.7 cm solar flux (SFI) is a proxy for the ionizing radiation that builds the F layer. Higher flux generally means a higher MUF, so 15, 12 and 10 meters are more likely to support F2 paths. But SFI is a single daily snapshot. It says nothing about your path, the time of day, or whether the D layer is eating your signal. The sunspot number follows the roughly 11-year cycle and is better for long-term expectations than for tonight's operating decisions.
The A index is a daily average of geomagnetic activity, and the K index is a 0 to 9 measure for each three-hour period. Quiet conditions (low A, K of 0 to 2) usually favor stable HF paths. A rising K, especially on paths crossing high latitudes, often brings flutter, absorption or a depressed MUF. The Kp value is a planetary average, though, so a local K can differ from it. A strong flare can also cause a sudden daytime radio blackout on the sunlit side of the Earth, even when the A and K values look fine.
Then there is layer behavior. In daylight the D layer absorbs lower HF, which is why 160, 80 and 40 meters are poor for longer paths at midday but improve around sunset and at night. The F layer, and F2 in particular, carries the long-distance work on the higher bands. Gray line paths work because the D layer is fading or has not yet formed along the terminator, while the F layer is still supporting propagation.
Beyond the F layer there are the "other" modes. Sporadic E can bring short-skip openings on 10 meters and 6 meters, and occasionally higher, with a strong seasonal pattern in mid-latitudes. Tropospheric ducting on VHF and UHF depends on temperature inversions and weather patterns rather than solar numbers. NVIS is the opposite use case: high-angle signals on a frequency below the critical frequency, which fills in regional coverage when the skip zone would otherwise leave gaps.
For checking in real time, I see these tools used most:
My questions: when the indices and the live data disagree, which do you trust? Do you have a routine for a quick band check before you commit to an operating session? And how do you treat WSPR spots given that they are low power, narrow bandwidth and station-dependent?
Link to comment
https://www.hamradiobase.com/forums/topic/11610-how-do-you-decide-if-a-band-is-really-open-sfi-k-index-voacap-wspr-and-beacons-compared/Share on other sites