ⓘ Callsign lookups are in real time via the FCC database.
Vanity callsign availability is refreshed daily at 6:00 AM CST.
The vanity search may be unavailable for a few minutes during this update.
Live DX spots
Live DX Spots — 70cmvia PSKReporter · scroll or pinch to zoom
Band
Mode
Time
Loading map data…
MHzDXSpotterInfo
Recent spots—
Select a band above to load spots
Ready — select a band to fetch live spots
One-radio, one-wire activation kit: EFHW or linked dipole on a telescopic pole?
This is a planning question for anyone building or rebuilding a lightweight go-kit for POTA and SOTA. The usual setup is a QRP or 10 W radio, a 10 m fiberglass telescopic pole, a LiFePO4 pack and one wire antenna. The antenna choice shapes the rest of the kit, so it's worth deciding on purpose.
The end-fed half-wave (EFHW) has some real advantages. You hang the wire off the pole as an inverted-V or sloper, run a short piece of coax, and you're on air. A 40 m EFHW is roughly 20 m of wire and is resonant on 40, 20, 15 and 10, with 30 and 17 usually workable. Hopping bands is just a matter of turning the dial and checking SWR. The catches are that the 49:1 or 64:1 transformer is lossy if it's poorly built, the feedpoint is high impedance and sensitive to what's around it, and it wants a counterpoise, which might be a short wire or just the coax shield. A common-mode choke at the radio end often tames RF-in-the-shack problems.
A linked dipole is center-fed and balanced, so it's less fussy about what's under and around it. Each band is a resonant section joined by links, and when the links are open the dipole is shorter, which sets the band. It's easy to trim and predictable. The downside is that changing bands means lowering the pole or walking to the links, which is a pain on a windy summit or when you're chasing spots across bands.
Other things that tend to matter more than the wire type:
Pole height and guying. A 10 m pole with the apex guyed to a stake or a pack keeps an inverted-V from flopping. Keep wire clear of carbon poles, since carbon conducts and will detune things.
Power. LiFePO4 is about 12.8 V nominal and sits near 13.2 V for most of the discharge before dropping fast, so it suits a 13.8 V rig well. Check your radio's maximum input voltage against a freshly charged pack at about 14.4 V. Put a fuse near the battery. Most LiFePO4 packs shouldn't be charged below freezing unless the BMS says it's safe. Solar is mainly worth carrying for multi-day camping, not a two-hour activation.
Logging. Paper is still the best fallback when a tablet dies or the cold kills a battery. Keep a pencil, since pens fail in the cold and damp. Check the current activation thresholds for your program (POTA and SOTA have different minimums) and what the park or summit rules say about where you can set up.
Weather. If thunder is audible or a storm is building, a pole with a wire up is not where you want to be. Take it down early and leave. Lightning rules of thumb are useful, but the safe call is to start descending before the storm is on you.
So what's your pick for a first or only antenna, and what made you choose it? Terrain, band mix and how much you hate carrying weight all change the answer.
This is a planning question for anyone building or rebuilding a lightweight go-kit for POTA and SOTA. The usual setup is a QRP or 10 W radio, a 10 m fiberglass telescopic pole, a LiFePO4 pack and one wire antenna. The antenna choice shapes the rest of the kit, so it's worth deciding on purpose.
The end-fed half-wave (EFHW) has some real advantages. You hang the wire off the pole as an inverted-V or sloper, run a short piece of coax, and you're on air. A 40 m EFHW is roughly 20 m of wire and is resonant on 40, 20, 15 and 10, with 30 and 17 usually workable. Hopping bands is just a matter of turning the dial and checking SWR. The catches are that the 49:1 or 64:1 transformer is lossy if it's poorly built, the feedpoint is high impedance and sensitive to what's around it, and it wants a counterpoise, which might be a short wire or just the coax shield. A common-mode choke at the radio end often tames RF-in-the-shack problems.
A linked dipole is center-fed and balanced, so it's less fussy about what's under and around it. Each band is a resonant section joined by links, and when the links are open the dipole is shorter, which sets the band. It's easy to trim and predictable. The downside is that changing bands means lowering the pole or walking to the links, which is a pain on a windy summit or when you're chasing spots across bands.
Other things that tend to matter more than the wire type:
Pole height and guying. A 10 m pole with the apex guyed to a stake or a pack keeps an inverted-V from flopping. Keep wire clear of carbon poles, since carbon conducts and will detune things.
Power. LiFePO4 is about 12.8 V nominal and sits near 13.2 V for most of the discharge before dropping fast, so it suits a 13.8 V rig well. Check your radio's maximum input voltage against a freshly charged pack at about 14.4 V. Put a fuse near the battery. Most LiFePO4 packs shouldn't be charged below freezing unless the BMS says it's safe. Solar is mainly worth carrying for multi-day camping, not a two-hour activation.
Logging. Paper is still the best fallback when a tablet dies or the cold kills a battery. Keep a pencil, since pens fail in the cold and damp. Check the current activation thresholds for your program (POTA and SOTA have different minimums) and what the park or summit rules say about where you can set up.
Weather. If thunder is audible or a storm is building, a pole with a wire up is not where you want to be. Take it down early and leave. Lightning rules of thumb are useful, but the safe call is to start descending before the storm is on you.
So what's your pick for a first or only antenna, and what made you choose it? Terrain, band mix and how much you hate carrying weight all change the answer.
Link to comment
https://www.hamradiobase.com/forums/topic/11660-one-radio-one-wire-activation-kit-efhw-or-linked-dipole-on-a-telescopic-pole/Share on other sites