Building a ham go-kit in layers: what goes in the grab-and-go bag, what stays in the tub, and what you plan to do at home
- Replies 2
- Views 15
- Created
- Last Reply
A better way to browse. Learn more.
A full-screen app on your home screen with push notifications, badges and more.
Most go-kit threads turn into gear lists, and gear lists don't tell you whether a kit will work. Here is a layered way to think about it, and I'd like to hear where you'd change it.
Layer 1: the grab-and-go bag. This is what you can pick up in under a minute. A dual-band HT, a spare battery or a battery case for AA cells, and a short flexible antenna are the core. Add a better antenna such as a roll-up J-pole or a telescoping whip on a BNC or SMA adapter. Add a printed copy of your local repeater list, simplex frequencies, and net schedules, because a phone may be dead or unreachable. Also pack a headlamp, a pen and paper for logging, and a small USB power bank with the right cables. Check that your HT charger works from 12 V or USB. A charger that only works from a wall outlet is a weak point when the grid is down.
Layer 2: the tub or box. This holds what you need for a longer deployment or a night at home without power. A mobile or base radio, 12 V power distribution with Powerpoles, a fused lead, a battery (many people use LiFePO4 now), coax, a mast or a way to hang a wire antenna, and a basic SWR meter or antenna analyzer all belong here. Label the connectors and keep a short checklist taped inside the lid. Do a full setup at least once, ideally outdoors in bad light, so you find the missing adapter before it matters.
Layer 3: the plan. Gear without a plan is a hobby, and a plan without gear is a wish. Decide who you will contact, on what frequency, and at what time. Check your local ARES or club net schedule, and ask your Emergency Coordinator whether there are registration or training requirements before you show up expecting to help. Also decide what you will do if repeaters are down. That usually means a simplex plan, for example a primary and an alternate frequency on 2 m and 70 cm, with set check-in times.
Power and solar. Work out the load first. A 5 W HT on receive uses very little, but a 50 W mobile transmitting does not, so estimate your daily amp-hours before buying panels. A solar panel should go through a charge controller, not straight into a battery, and a fuse belongs close to the battery positive terminal. Keep an eye on noise too. Some cheap controllers and inverters make hash across HF and VHF, so test with the radio before you rely on them.
Family communication. Not every family member will hold a ham license. GMRS needs a license in the US, but FRS and MURS do not, so check current FCC rules for details and power limits. A NOAA weather radio with SAME alerting and battery backup is cheap and useful. Add an out-of-area contact for everyone to check in with, and a written meeting point. Text messages often get through when voice calls don't, but don't count on that.
First aid and supplies. Keep a real first-aid kit, any prescriptions that matter, water, and some food in the same place as the radio gear, or in a bag next to it. Training matters more than the kit. A tourniquet you don't know how to use isn't much help, so take a local class if you can.
Questions for the thread: What's the one item you've seen people forget most often? How do you decide between building a kit around an HT and building around a mobile rig? And how often do you actually rotate batteries and run a full test?
Link to comment
https://www.hamradiobase.com/forums/topic/11690-building-a-ham-go-kit-in-layers-what-goes-in-the-grab-and-go-bag-what-stays-in-the-tub-and-what-you-plan-to-do-at-home/Share on other sites