Building a ham go-kit that actually works: power, antennas, FRS/GMRS/MURS backups and a family comms plan
- Replies 2
- Views 15
- Created
- Last Reply
A better way to browse. Learn more.
A full-screen app on your home screen with push notifications, badges and more.
Let's pull together a practical readiness checklist for ham operators. Gear lists are easy to find. What's harder is deciding what goes in the kit, what gets tested, and what the plan is when the repeater, the grid, or the cell network isn't there. Here's a framework to argue with, with room for everyone's own setups.
Start with the mission, not the gear. A kit built for "I need to check on my family across town" looks very different from one built for "I'm reporting to a served-agency shelter for a few shifts." A reasonable split is three layers: a pocket-sized personal layer (HT, spare battery, earpiece, a written frequency card), a grab-and-go bag (mobile or portable station, power, antennas, logs, basic supplies), and a home layer (larger battery bank, solar, a better antenna, stored supplies).
HT kit basics. Carry at least one spare battery and an AA or alkaline battery case if your radio supports one, since that works when you can't recharge. Swap the stock rubber duck for a better antenna, or keep a roll-up J-pole or similar on hand. Know your connector: SMA male versus female catches many people out. Add a short adapter set, a headset or speaker-mic, and a printed sheet listing local repeaters, simplex frequencies, tones/offsets, and net times. Don't rely on programming you can't read without the radio's screen or phone app.
Mobile and portable station. A 12 V radio, power cable with fuse, and Anderson Powerpole connectors make a flexible base. Standardizing on Powerpoles lets you move between a vehicle, a battery, and a power supply without rewiring. Add a mag mount or clamp mount antenna, spare coax, a small SWR meter or antenna analyzer if you use HF, and a pen-and-paper log. Paper still works when screens die.
Power budgeting. Do the math ahead of time. Watt-hours (Wh) = amp-hours × volts. A 12 V, 20 Ah LiFePO4 battery is roughly 240 Wh of nominal capacity. A VHF/UHF radio drawing about 1 A on receive and 10 to 12 A on high-power transmit has a very different average draw depending on how much you transmit. Estimate your duty cycle, add a margin, and then test it by running the kit for a few hours. For solar, the panel's rated watts are a best case. Real output depends on sun angle, temperature, and cloud cover. A charge controller sized for the panel and battery chemistry is important, and a controller or charger meant for lead-acid is not automatically right for lithium or LiFePO4.
Antenna kit. Common choices include a roll-up or slim J-pole for VHF/UHF, a mag-mount antenna on a vehicle roof, and a portable HF wire antenna (an end-fed or a dipole) with a light mast or a tree-launch line. Pack rope or paracord, tape, a few tools, and a way to tie off coax. A pre-cut, pre-labeled antenna you've already deployed beats an untried one every time.
Backup services: FRS, GMRS, MURS, weather. These aren't ham bands, but they're useful for family and neighbors who don't hold licenses. FRS is license-free and works for short-range coordination. GMRS shares some frequencies with FRS but allows more power and external antennas on certain channels and requires a license in the US, which can cover a household. MURS is a license-free VHF service with a small set of channels and low power. A NOAA weather radio, ideally one that supports SAME alerts and has battery backup, gives you official warnings without internet. Check current FCC rules and radio type-acceptance before buying, since equipment that mixes services can cause rule problems.
Family communication plan. Write it down and keep a copy in every bag. Include an out-of-area contact (text and calls sometimes work when local lines are overloaded), a primary and alternate meeting point, a check-in schedule, and which radio channel or frequency to try first. Decide ahead of time what family members should do if they can't reach each other: for example, try the agreed simplex channel at the top of each hour. Teach non-licensed family members how to use FRS or GMRS radios, and practice it.
First aid and supplies. A basic kit should cover bleeding control, wound care, gloves, medications you rely on, and a few comfort items. Pair that with training, since tools like tourniquets are only useful if you know how to apply them. Add water, snacks, a headlamp with spare batteries, a hand-crank or battery lantern, a multitool, rain gear, and copies of key documents. Check expiration dates on a schedule, such as when daylight saving time changes.
Grid-down plan. Know which local nets are active, which frequencies your local ARES/emergency group uses, and who your served-agency contacts are. In an emergency, don't clog frequencies with chatter. Listen first, identify as required, keep traffic short, and use plain language. Stay within your license privileges and the guidance of your local emergency coordinator.
To get things started: what's in your grab-and-go bag that you'd never leave out, and what did you pack once and never use? Also, how do you test your kit, and how often?
Link to comment
https://www.hamradiobase.com/forums/topic/11713-building-a-ham-go-kit-that-actually-works-power-antennas-frsgmrsmurs-backups-and-a-family-comms-plan/Share on other sites