☀
Solar
SFI
99
SN
26
A
6
K
0
Quiet
X-Ray
B2.3
Wind
384.8 km/s
Aurora
1
Updated 13:30 UTC
HamQSL · N0NBH
Day
80/40m Good 30/20m Good 17/15m Fair 12/10m Poor
Night
80/40m Good 30/20m Good 17/15m Fair 12/10m Poor
Callsign Lookup
_
Vanity Call Signs Available
Enter filters above and click Search.
ⓘ Callsign lookups are in real time via the FCC database.
Vanity callsign availability is refreshed daily at 6:00 AM CST.
The vanity search may be unavailable for a few minutes during this update.
Propagation numbers are easy to collect, but it is harder to turn them into a decision about whether to call CQ on 15 m or give up and work on the antenna. This thread is for comparing methods. The question is which indicators you trust, and when you stop reading numbers and look at live data.
Here is my rough mental model, so you can tell me where it is wrong.
Solar flux (SFI, the 10.7 cm flux) is a proxy for how strongly the sun is ionizing the upper atmosphere. Higher flux generally means a higher F-layer MUF, so 15 m, 12 m and 10 m are more likely to open for long-distance paths. Near solar minimum the upper HF bands are often dead for long stretches. Near solar maximum they can stay open for hours. SFI is a daily number and the sunspot cycle is a multi-year trend. Neither says whether a specific path is open right now.
The A index and K index describe geomagnetic disturbance. K is a 3-hourly value from 0 to 9, and A is a daily average derived from it. Quiet conditions (low K) are usually good for HF, especially polar paths. A rising K can depress F-layer ionization and make paths flutter or vanish. Check whether you are looking at a planetary Kp or a K value from a single magnetometer, because they can differ.
Then there is the D layer. It exists in daylight and absorbs lower HF, so 160 m, 80 m and often 40 m are weak on daytime paths. Absorption falls with rising frequency, which is why 20 m and up can work while 80 m is useless at midday. A solar flare can cause a sudden blackout on the sunlit side of the Earth, with HF going quiet across a whole band.
My question is what you check first when you sit down at the rig. A few options:
Does anyone have a routine that keeps this quick without turning it into a hobby of its own?
Link to comment
https://www.hamradiobase.com/forums/topic/11844-how-do-you-decide-a-band-is-actually-open-sfi-and-k-index-versus-wspr-beacons-and-real-spots/Share on other sites