From FM birds to linear transponders: handling Doppler, antennas and tracking for LEO and QO-100
- Replies 2
- Views 41
- Created
- Last Reply
A better way to browse. Learn more.
A full-screen app on your home screen with push notifications, badges and more.
I'd like to compare notes on the practical side of satellite work, starting with the progression most operators follow: FM birds first, then linear transponders, then maybe a geostationary bird like QO-100. Each step changes what you need in antennas, tracking and operating habits.
FM satellites such as SO-50, AO-91 and AO-92 (and the ISS crossband repeater when it is switched on) are single-channel repeaters. Only one station at a time can use the uplink, so you are competing with everyone else in the footprint. Check current status on the AMSAT pages before you plan a pass, because operating modes, access tones and availability change. Some FM birds need a CTCSS tone on the uplink, and some have to be armed first. The ISS APRS digipeater on 145.825 MHz is a different animal. It is 1200 baud packet, so you can listen with a simple rig and a decoder, and you don't need full duplex.
Doppler is the first real hurdle. At 435 MHz, a LEO pass can shift the signal by roughly 9 to 10 kHz from AOS to LOS. On 145 MHz the shift is about a third of that. On FM you can usually get by with a few memory channels or by stepping the 70 cm side in 5 kHz increments. On a linear transponder like RS-44 you must also correct for Doppler on the uplink, otherwise your SSB signal lands in the wrong place in the passband. Software helps here. Gpredict can drive a rig through Hamlib's rigctld, and SatPC32 can do the same through its own interface modules. Both can also drive a rotator.
For antennas, the common first setup is a handheld Arrow-style dual-band Yagi with a duplexer and a rig or HT that allows full duplex, so you can hear yourself on the downlink. It is cheap and portable, but it demands constant pointing and polarization juggling. Larger Yagis on an az/el rotator are easier to operate. They also add cable loss, mast weight and rotator-control questions. With high-elevation passes, you also have to deal with the fact that the beam is not always pointing where the pass is simplest.
RS-44 gives long passes because of its higher orbit, and it is inverting, so tuning up moves the downlink down. Grid squares matter because many QSOs are just callsign, grid and signal report. QO-100 is a different world: it's geostationary, so there's no Doppler, but you need a 2.4 GHz uplink and a 10 GHz downlink, with a dish and LNB that are stable enough to hold frequency.
Which part of this has been hardest to get right: Doppler control, antenna handling, or finding the best passes? Which software and hardware combinations are people using for rig and rotator control?
Link to comment
https://www.hamradiobase.com/forums/topic/10763-from-fm-birds-to-linear-transponders-handling-doppler-antennas-and-tracking-for-leo-and-qo-100/Share on other sites