Building a ham go-kit in layers: what goes in the grab-and-go, what stays in the vehicle, and what stays home
- Replies 2
- Views 31
- Created
- Last Reply
A better way to browse. Learn more.
A full-screen app on your home screen with push notifications, badges and more.
Most go-kit discussions turn into a gear list, which makes it easy to end up with one heavy bag that is wrong for most situations. A more useful way to plan is in layers, each matched to how much warning you get and how long you expect to be out. Here is a framework to pick apart, and I'd like to hear where yours differs.
Layer 1: the grab-and-go (minutes of warning, hours to a day or two). This is the bag by the door. Think HT, a spare battery pack or a AA/AAA battery case, a better antenna than the stock rubber duck (a flexible whip or a roll-up J-pole), a short coax jumper, a printed frequency card, pen and paper, a headlamp, a small power bank with the right cables, and basic first aid. The printed card matters more than people expect. Include local repeaters with offsets and tones, simplex frequencies, your net schedules, and your family's check-in times, because a dead radio with a locked menu is no use to anyone. Keep the card in a ziplock bag.
Layer 2: the vehicle or mobile kit. A mobile rig gives you more power, a better antenna, and a built-in battery. If you run a dual-band mobile, the kit should include a fused power lead, a spare antenna mount or a magnetic mount, and a way to run the radio when the engine is off without draining the starting battery. Decide in advance how long you will idle the engine versus run the radio on a separate battery. A small LiFePO4 pack with Powerpoles and a fuse near the battery terminal is a common approach because it keeps the radio off the vehicle's starting battery entirely.
Layer 3: the home or fixed-site setup. This is where solar and a larger battery bank make sense. A rough sizing method is to list each device's draw, estimate hours of use per day, and add them up in watt-hours. Many HF rigs at 100 W transmit draw about 20 A at 13.8 V, but average draw over a day is far lower because you mostly listen. Receive current for many rigs is under 1 A, but check your own radio's manual rather than trusting a rule of thumb. Size the panel for what you actually use, then add margin for cloudy days. Use a charge controller, and check the panel's open-circuit voltage against the controller's input limit, especially in cold weather when panel voltage rises.
Antennas. For VHF/UHF, a roll-up J-pole or a simple 1/4-wave ground plane hung from a tree branch or mast will usually beat an HT's rubber antenna by a useful margin. For HF, a 40 m or 80 m NVIS-style dipole kept low (a modest height above ground) is a common choice for regional communication when the repeater system is down. Pack paracord, a throw weight, a few stakes, and a spare length of coax with connectors you have actually tested. Test your kit's antenna setup at a park before you need it. SWR readings and feedline losses are easier to deal with in daylight with no stress.
License-free and other services. Not every family member will have a ham ticket, so it is worth knowing the options. FRS needs no license in the US, but range is short. GMRS requires a license in the US, but one license covers the licensee's immediate family, and it allows higher power and repeater use on certain channels. MURS (five VHF channels near 151–154 MHz) is license-free and has no repeaters. One caution: use radios that are certified for the service you are using. A ham HT that can be programmed onto GMRS or MURS frequencies is not necessarily legal to operate there, so check the rules for your radio and country. Rules differ outside the US, so look up your own regulator.
Weather radios. A NOAA-style weather radio with SAME alerting on one of the 162 MHz channels provides warnings without needing cell service or internet. Choose one that can run on batteries and keep spares or a crank/solar backup, then test the alerts occasionally. Some hand-held radios can also receive weather channels, but dedicated alerting is useful overnight when you may not be monitoring.
Family communication plan. A radio does little good if only you know how to use it. A written plan should cover an out-of-area contact (text messages often get through when voice calls do not), at least two meeting points, a check-in schedule such as the top of the hour on a certain frequency, and who is responsible for children, pets, and medications. Write down phone numbers on paper because phones die. Decide in advance which simplex channel you will try first, and which one is the backup.
First aid and supplies. Pack personal medications with a realistic supply, bandages, gauze, tape, gloves, a thermometer, and any items for known conditions in your household. If you carry hemorrhage-control items such as a tourniquet, take a hands-on class from a qualified instructor, because owning the item is not the same as knowing how to use it. Add water, snacks, a basic tool kit, spare glasses, and hearing-aid batteries if applicable. Rotate batteries and consumables on a schedule, perhaps when you change clocks twice a year.
So the questions for the thread: what do you think belongs in the first layer that people leave out? How do you decide between a larger battery bank and more solar? And what is your plan for a day when the repeater is down and nobody answers on simplex?
Link to comment
https://www.hamradiobase.com/forums/topic/10828-building-a-ham-go-kit-in-layers-what-goes-in-the-grab-and-go-what-stays-in-the-vehicle-and-what-stays-home/Share on other sites