Skip to content
View in the app

A better way to browse. Learn more.

Ham Radio Base

A full-screen app on your home screen with push notifications, badges and more.

To install this app on iOS and iPadOS
  1. Tap the Share icon in Safari
  2. Scroll the menu and tap Add to Home Screen.
  3. Tap Add in the top-right corner.
To install this app on Android
  1. Tap the 3-dot menu (⋮) in the top-right corner of the browser.
  2. Tap Add to Home screen or Install app.
  3. Confirm by tapping Install.
Ham Radio Base — Education, Resources, Projects and Community
☀ Solar
SFI 99
SN 26
A 6
K 0 Quiet
X-Ray B2.3
Wind 412.9 km/s
Aurora 1
Updated 14:00 UTC HamQSL · N0NBH
Day 80/40m Good 30/20m Good 17/15m Fair 12/10m Poor
Night 80/40m Good 30/20m Good 17/15m Fair 12/10m Poor

Callsign Lookup
_
Vanity Call Signs Available
Enter filters above and click Search.
ⓘ Callsign lookups are in real time via the FCC database. Vanity callsign availability is refreshed daily at 6:00 AM CST. The vanity search may be unavailable for a few minutes during this update.
Live DX spots
Live DX Spots — 70cm via PSKReporter · scroll or pinch to zoom
Band
Mode
Time
Loading map data…
MHz DX Spotter Info
Recent spots —
Select a band above to load spots
Ready — select a band to fetch live spots

Is the band actually open? Comparing SFI, K index, beacons, WSPR and VOACAP for a quick answer

ci_cover.jpg

Propagation numbers are easy to collect and easy to misread. A spot on the dial can sound dead while the indices look fine, or the indices can look bad while a path is open. Here is how I'd sort out which tools answer which question, and I'd like to hear where other people draw the line.

Indices tell you the background, not the path. The 10.7 cm solar flux (SFI) is a proxy for the ionizing radiation that builds the F layer. Higher SFI usually means a higher MUF, so 15m, 12m and 10m have a better chance of supporting DX. Around solar minimum the flux sits near its floor, and the upper HF bands often need other mechanisms to be useful. The A index is a daily, roughly linear summary of geomagnetic activity. The K index is a 3-hour, quasi-logarithmic value from 0 to 9. A quiet field (low A, K of 0 to 2) is generally friendlier, especially on paths that cross high latitudes. A K of 4 or more, or a rising planetary Kp, often brings flutter, weak signals and depressed MUF on polar routes. Even then, mid-latitude north-south paths can hold up.

D layer versus F layer. The D layer exists only on the sunlit side of the Earth. It absorbs low frequencies, with absorption falling roughly with the square of frequency, so 160m and 80m are weak in daylight and 40m is often limited to shorter paths. After sunset the D layer fades and the lower bands open for longer hops. The F layer keeps refracting through the night, but its MUF drops as ionization decays. That is why 20m often stays workable into the evening while 10m closes. A solar flare can cause sudden D-layer absorption across the whole sunlit hemisphere. This produces a shortwave fadeout that has nothing to do with Kp.

Beyond F-layer skip. Sporadic E is patchy, short-lived E-layer ionization, mostly in the summer season in each hemisphere, that can bring 10m, 6m and sometimes 2m openings over single-hop distances of about 1,000 to 2,300 km. Tropospheric ducting is a different animal. It comes from temperature inversions and stable high-pressure weather, especially over water, and favors VHF and UHF. The solar indices tell you almost nothing about either one.

Real-time checks. The NCDXF/IARU beacon network uses 14.100, 18.110, 21.150, 24.930 and 28.200 MHz in a repeating 3-minute cycle. Each beacon sends its call and then steps down in power from 100 W to 10 W, 1 W and 100 mW. Hearing the low-power steps tells you more than hearing only the first dash. WSPR works differently. Stations transmit and decode in 2-minute slots, and reports go to a public database, so you can see which paths worked at which power level and SNR. PSK Reporter and the Reverse Beacon Network do something similar for digital modes and CW. These show actual paths and actual receivers, but remember they are biased toward where the receivers are.

Planning ahead. VOACAP and similar tools predict monthly median conditions from a smoothed sunspot number, your antennas, power and noise assumptions. They are good for asking when 17m is likely to open to a region, or which band is the best bet for a scheduled contact. They are not a live forecast. For regional work, NVIS on a horizontal antenna low over the ground typically uses frequencies below the critical frequency of the F layer. That usually means 40m or 60m by day and 80m by night, and the useful band can change within hours. The gray line is a real enhancement along the sunrise and sunset terminator, mostly on the low bands, but it is not magic. Path geometry, noise and antenna pattern still decide who gets through.

What's your workflow? Do you look at indices first, or go straight to beacons and spots? And do you trust VOACAP for scheduling?

  • Replies 2
  • Views 67
  • Created
  • Last Reply

Top Posters In This Topic

Featured Replies

  • Moderators

I'd go spots first and indices second. The indices are good for explaining a result after the fact, but a decoded WSPR spot or an RBN skimmer report is direct evidence that a path existed. One caveat is that WSPR power and antenna matter a lot. A 5 W signal decoded at -20 dB can mean something very different from a 1 W signal at the same SNR, so filter reports by power before you compare bands. Also check the time window. A spot from 40 minutes ago on 15m can be stale when the MUF is changing near sunset.

For K index, I'd also check whether you're looking at planetary Kp or a local K from a nearby magnetometer. They can disagree, and the effect depends on whether your path runs through the auroral zone. A Kp of 5 can wreck a transpolar path while a south-to-north path at lower latitude barely changes.

  • Administrators

VOACAP is most useful if you treat its output as probability, not a yes or no. The reliability figure is about how often the circuit meets your required SNR over the month at that hour. A low number doesn't mean a path is impossible on a given day, and a high one doesn't promise it. The answers also change with your inputs: antenna gain at the takeoff angle, transmit power, the noise level for your location, and the required SNR for your mode. A CW or FT8 requirement is far lower than SSB.

It also helps to compare it with beacons. If VOACAP says 20m should be strong to South America at a given hour but the 14.100 beacons from there are absent, the cause could be a geomagnetic disturbance, a flare, or just your local noise or antenna. That tells you whether to look at space weather or at your own station. For sporadic E, VOACAP won't help. Watch 6m beacons, spot clusters and other stations' reports, since those openings can start and vanish quickly.

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

Affiliate Disclosure: As an Amazon Associate, Ham Radio Base earns from qualifying purchases. Some links throughout this website may be affiliate links. If you purchase a product through one of these links, we may earn a commission at no additional cost to you. Your support helps us continue creating free articles, tutorials, reviews, and resources for the amateur radio community. N0TLB © Ham Radio Base - Powered by the Ham CQ DX Community. All rights reserved.

Search

Search

Configure browser push notifications

Chrome (Android)
  1. Tap the lock icon next to the address bar.
  2. Tap Permissions → Notifications.
  3. Adjust your preference.
Chrome (Desktop)
  1. Click the padlock icon in the address bar.
  2. Select Site settings.
  3. Find Notifications and adjust your preference.