Skip to content
View in the app

A better way to browse. Learn more.

Ham Radio Base

A full-screen app on your home screen with push notifications, badges and more.

To install this app on iOS and iPadOS
  1. Tap the Share icon in Safari
  2. Scroll the menu and tap Add to Home Screen.
  3. Tap Add in the top-right corner.
To install this app on Android
  1. Tap the 3-dot menu (⋮) in the top-right corner of the browser.
  2. Tap Add to Home screen or Install app.
  3. Confirm by tapping Install.
Ham Radio Base — Education, Resources, Projects and Community
☀ Solar
SFI 99
SN 26
A 6
K 0 Quiet
X-Ray B2.3
Wind 412.9 km/s
Aurora 1
Updated 14:00 UTC HamQSL · N0NBH
Day 80/40m Good 30/20m Good 17/15m Fair 12/10m Poor
Night 80/40m Good 30/20m Good 17/15m Fair 12/10m Poor

Callsign Lookup
_
Vanity Call Signs Available
Enter filters above and click Search.
ⓘ Callsign lookups are in real time via the FCC database. Vanity callsign availability is refreshed daily at 6:00 AM CST. The vanity search may be unavailable for a few minutes during this update.
Live DX spots
Live DX Spots — 70cm via PSKReporter · scroll or pinch to zoom
Band
Mode
Time
Loading map data…
MHz DX Spotter Info
Recent spots —
Select a band above to load spots
Ready — select a band to fetch live spots

Part 97 compliance checklist: ID timing, third-party traffic, power, RF exposure, repeater control, and license renewal

ci_cover.jpg

Part 97 is long, and the rules that trip people up usually sit in different subparts. Here is a set of related questions to work through as a compliance review of a typical home station that also has a repeater link and some digital modes.

1) What are the real station identification requirements, and do they change for digital modes and repeaters? 2) Where is the line on third-party traffic, especially internationally? 3) How is the 1500 W limit measured, and where do lower limits apply? 4) What counts as a prohibited transmission, and where do people misread the business-communications rule? 5) Do I actually have to do an RF exposure evaluation? 6) How seriously should I take spurious emissions with an amplifier? 7) How do control operator, automatic control, and auxiliary station rules fit together for a repeater and its links? 8) What does enforcement look like in practice, and what are the license term and renewal rules?

Please cite section numbers where you can, so people can check the current text of 47 CFR Part 97 on eCFR. This is general discussion, not legal advice.

  • Replies 2
  • Views 56
  • Created
  • Last Reply

Top Posters In This Topic

Featured Replies

  • Moderators

I'll take the first four.

Station ID (§97.119): you must give your call sign at the end of each communication and at least every 10 minutes during a communication. Phone IDs must be in English, and you can use a standard phonetic alphabet. CW and digital IDs are also allowed. For digital modes, the call sign must be sent in a way the receiving station can decode. Many FT8-style exchanges carry the call sign in the message itself. A repeater with automatic control must also identify on its own schedule, and the licensee is responsible for that. Also remember that 'end of each communication' is not the same as 'end of each transmission'. In a long roundtable, the 10-minute clock is the one that matters.

Third-party traffic (§97.115): a third party is someone who is not a control operator of either station but takes part in the exchange, such as a family member who gets on the mic. Domestically this is generally fine as long as the control operator is present and ready to supervise, and the content is otherwise legal. Internationally it is only allowed with countries that have a third-party traffic agreement with the US. The big exception is that if the third party is a person eligible to be the control operator of your station, such as a licensed ham, the international restriction does not apply. Also check the other country's own rules, and §97.117 on international communications. Automatically controlled stations have extra limits on third-party traffic, with some exceptions for data modes.

Power (§97.313): the 1500 W figure is peak envelope power at the transmitter output, not ERP. In general you must use the minimum power necessary for the communication, so the 1500 W figure is a ceiling, not a default. Lower limits apply in places. For example, Technician privileges on HF are capped at 200 W PEP, and 30 meters is also 200 W PEP. The 60 meter band, 2200 meters, and 630 meters have their own rules, and several of those are written in ERP or EIRP, so look at the specific band section and don't assume. Also check §97.301–97.305 for which license class may use which segments.

Prohibited transmissions (§97.113): the common misunderstandings are these. No one may be paid to be a control operator, with narrow exceptions such as teachers using amateur radio in a classroom. You can't use the service for communications in which you or your employer have a pecuniary interest, with limited exceptions. Occasional sale of your own surplus ham gear is acceptable. Also prohibited are music (outside a few special cases), obscene or indecent language, deliberately false or deceptive signals, and messages encoded to obscure their meaning. That last point is why encryption is off the table for ordinary amateur communications, apart from limited exceptions like control of space stations or model craft. In an emergency involving the immediate safety of human life or protection of property, other rules allow more flexibility (§97.403).

  • Moderators

Picking up the rest, with a couple of cautions.

RF exposure: §97.13(c) says that if your station's power and antenna configuration exceed the thresholds in the FCC's RF exposure rules (§1.1307(b)), you must perform a routine evaluation. The thresholds depend on the band and are expressed in terms of ERP, so a low-power station may fall under an exemption but a high-power or high-gain VHF/UHF station may not. The evaluation can be done with the FCC's OET Bulletin 65 methods, published calculators, or measurements. You need to consider both your own household (uncontrolled environment) and any place people can reach near the antenna. Mode and duty cycle matter, since SSB, CW, and FM have different average power. Evaluation doesn't mean a license filing. It means you are responsible for being able to show the station meets the limits in §1.1310. For practical safety, keep the antennas well away from where people stand or sit.

Spurious emissions (§97.307): the rules set attenuation limits that depend on band and power. The HF requirement for newer equipment is at least 43 dB below the mean power of the fundamental, and VHF/UHF stations above certain power levels have tighter limits. The rule applies to your station as a whole, not just the radio as it came from the factory. Common causes of problems are an overdriven amplifier, too much audio or ALC action, a missing or wrong low-pass filter, and an amp used outside the band it was designed for. If you add an amplifier, check the output on a spectrum analyzer or SDR with an appropriate attenuator and compare it to the limit, and don't just assume it is fine.

Control and auxiliary operation: every amateur station needs a control operator (§97.103, §97.105). The licensee is responsible for proper operation unless the licensee designates someone else. The control types are local, remote, and automatic (§97.109). Automatic control is only permitted for specific station types such as repeaters, auxiliary stations, and beacons, with rules for digital stations too. A repeater control operator must be able to shut the repeater down if it malfunctions. Auxiliary stations (§97.201), for example links and control links, are limited to certain bands and segments. For a repeater, also read §97.205 on repeater station rules and the coordination provisions.

Enforcement: the FCC's Enforcement Bureau can issue warning notices and notices of violation, and in serious cases can pursue forfeitures or license action. Deliberate interference, ID violations, and unlicensed operation draw more attention than minor paperwork problems. Volunteer monitoring programs exist, but they do not have FCC enforcement authority.

License term and renewal: an amateur license is valid for 10 years (§97.25). You can file a renewal in the ULS within 90 days before expiry. If you miss the date, a 2-year grace period (§97.21) lets you renew, but you can't transmit during it. After the grace period, the license is gone and you would need to take the exam again. Keep your mailing address and email address current in ULS. Fee requirements have changed over time, so check the FCC's current fee schedule before filing.

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

Affiliate Disclosure: As an Amazon Associate, Ham Radio Base earns from qualifying purchases. Some links throughout this website may be affiliate links. If you purchase a product through one of these links, we may earn a commission at no additional cost to you. Your support helps us continue creating free articles, tutorials, reviews, and resources for the amateur radio community. N0TLB © Ham Radio Base - Powered by the Ham CQ DX Community. All rights reserved.

Search

Search

Configure browser push notifications

Chrome (Android)
  1. Tap the lock icon next to the address bar.
  2. Tap Permissions → Notifications.
  3. Adjust your preference.
Chrome (Desktop)
  1. Click the padlock icon in the address bar.
  2. Select Site settings.
  3. Find Notifications and adjust your preference.