Skip to content
View in the app

A better way to browse. Learn more.

Ham Radio Base

A full-screen app on your home screen with push notifications, badges and more.

To install this app on iOS and iPadOS
  1. Tap the Share icon in Safari
  2. Scroll the menu and tap Add to Home Screen.
  3. Tap Add in the top-right corner.
To install this app on Android
  1. Tap the 3-dot menu (⋮) in the top-right corner of the browser.
  2. Tap Add to Home screen or Install app.
  3. Confirm by tapping Install.
Ham Radio Base — Education, Resources, Projects and Community
☀ Solar
SFI 99
SN 26
A 6
K 0 Quiet
X-Ray B2.3
Wind 412.9 km/s
Aurora 1
Updated 14:00 UTC HamQSL · N0NBH
Day 80/40m Good 30/20m Good 17/15m Fair 12/10m Poor
Night 80/40m Good 30/20m Good 17/15m Fair 12/10m Poor

Callsign Lookup
_
Vanity Call Signs Available
Enter filters above and click Search.
ⓘ Callsign lookups are in real time via the FCC database. Vanity callsign availability is refreshed daily at 6:00 AM CST. The vanity search may be unavailable for a few minutes during this update.
Live DX spots
Live DX Spots — 70cm via PSKReporter · scroll or pinch to zoom
Band
Mode
Time
Loading map data…
MHz DX Spotter Info
Recent spots —
Select a band above to load spots
Ready — select a band to fetch live spots

Rate vs. multipliers: how do you decide when to stop running and go hunting (and where does SO2R fit)?

ci_cover.jpg

I'd like to compare how people make the run-versus-search-and-pounce decision during a contest. It looks simple on paper: running gives the best sustained rate, and S&P gets you multipliers. In practice the decision depends on the exchange, the scoring formula, the band conditions and how tired you are.

A starting point is to put a number on a multiplier. In a typical score = QSO points × multipliers formula, one new multiplier is worth about (QSO points ÷ current multipliers) in extra score. If you have 600 QSO points and 60 multipliers, a new multiplier is worth roughly the same as 10 more QSOs. Early in the contest that number is small, so you should mostly run and not chase rare stuff. Later it grows, and a 90-second S&P detour for a new multiplier is a better deal than three minutes of calling CQ into a dead band. Check each contest's rules for whether multipliers count per band or once overall, because that changes the math a lot.

For deciding when to leave a run frequency, I watch the 10-minute rate against the 60-minute rate in N1MM. If the 10-minute rate falls well below what you'd expect from S&P plus a few multipliers, it's time to move. A single slow patch doesn't mean much, but a steady decline usually means the band is changing, the other stations have worked you, or someone louder has moved next to you.

Here are the questions I'd like to discuss:

1) Do you use a fixed schedule, such as running for a set time on each band, or do you decide dynamically from rate and the bandmap?

2) For SO2R, do you just use the second radio to find multipliers while CQing on radio 1, or do you also run on both radios when the bands are busy?

3) How do you handle spots in a unassisted category versus an assisted one? In assisted, how much do you trust Skimmer or cluster spots without confirming the call yourself?

4) What's your approach to fatigue over a 24- or 48-hour contest? Do you plan off-time around propagation dips, or just push through?

  • Replies 2
  • Views 49
  • Created
  • Last Reply

Top Posters In This Topic

Featured Replies

  • Moderators

On the multiplier math, one addition: the formula only gives a rough guide, because the cost of getting the multiplier matters too. A multiplier that needs a pileup on a rare station and takes five minutes may not beat staying on a good run frequency. A multiplier that's already spotted and sitting in your bandmap is nearly free. That's why I like having the Available Mults and Q's window and the bandmap visible at the same time, so the cheap multipliers are obvious.

For SO2R, the technique is less about hardware and more about timing. A common pattern is to call CQ on radio 1 with a message that has a short gap in it, and use that gap to tune radio 2 for multipliers. When someone answers on radio 1, you switch focus back to it. If you're going to do this, set up the headphones with one radio in each ear (stereo split) and get used to it with a practice session or a low-key contest before a big one. The failure mode isn't gear, it's the operator losing track of which radio is which. Also, a good SO2R controller or footswitch matters, because you don't want to be fumbling with keyboard shortcuts while a station is calling you.

Interference is the other practical limit. Two radios on the same band, or on bands that are harmonically related, can seriously desensitize each other without band-pass filters or stub filters, and antenna separation helps too. Plan this before the contest, not during it. Rules differ by category and contest, so check how your entry class treats SO2R and spotting.

  • Administrators

On Skimmer and packet spotting: treat spots as hints, not as logged data. Spots can be busted calls, a wrong frequency, or old news. With CW Skimmer or RBN-fed spots you usually get a callsign that's mostly right, but weak or fast stations can be decoded wrongly, and a wrong call logged is a lost QSO and sometimes a penalty. Click the spot, listen for the station to give its call, and only then log. If you're using a Telnet cluster in an assisted category, filter by band and mode so the bandmap isn't flooded, and remember that being in the assisted category is the price of using spots at all. In unassisted classes, spots from clusters or the Reverse Beacon Network aren't allowed, so make sure you're in the right category before you leave the telnet window connected.

On antennas, the most useful lesson is that a few good compromises beat a single big antenna. A stack of Yagis lets you pick a takeoff angle for the path, and a single high Yagi alone may be poor for some openings. On the low bands, the receive antenna often matters more than the transmit one, since a Beverage or a small receiving array can make the difference between hearing weak stations and sitting in noise. For SO2R, being able to put the two radios on different antennas, ideally with different polarization or direction, cuts the interference problem a lot.

For fatigue, the most reliable plan is to write one before the contest: when you'll sleep, when you'll eat, and which hours you expect to be slow. Making a call like 'band is dead, take a nap now' is much easier than staying on the radio at a 20-QSO-per-hour rate. Keep water and simple food within reach, lower the audio volume, and take short breaks to rest your ears and wrists. A rested operator usually makes far fewer mistakes in the last hours than one who stayed at the radio the whole time.

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

Affiliate Disclosure: As an Amazon Associate, Ham Radio Base earns from qualifying purchases. Some links throughout this website may be affiliate links. If you purchase a product through one of these links, we may earn a commission at no additional cost to you. Your support helps us continue creating free articles, tutorials, reviews, and resources for the amateur radio community. N0TLB © Ham Radio Base - Powered by the Ham CQ DX Community. All rights reserved.

Search

Search

Configure browser push notifications

Chrome (Android)
  1. Tap the lock icon next to the address bar.
  2. Tap Permissions → Notifications.
  3. Adjust your preference.
Chrome (Desktop)
  1. Click the padlock icon in the address bar.
  2. Select Site settings.
  3. Find Notifications and adjust your preference.