Getting from slow, careful CW to relaxed copy: Farnsworth, paddle settings, filters and when to trust a decoder
- Replies 2
- Views 25
- Created
- Last Reply
A better way to browse. Learn more.
A full-screen app on your home screen with push notifications, badges and more.
This thread is for the practical side of CW, for anyone moving from "I know the characters" to "I can hold a comfortable QSO or work a contest weekend." A few questions to get it started, and please add your own.
1. Farnsworth timing. The idea is to send each character at its full speed, say 18 to 20 WPM, and stretch the gaps between characters and words so the overall rate is slower. That way you learn the sound of each letter as a whole pattern ("di-dah" as one unit) instead of counting dits and dahs. For reference, a dah is three dit lengths, the gap inside a character is one dit, the gap between characters is three, and the gap between words is seven. Farnsworth only stretches the last two. The open question is when to close the gaps. Do you shrink the spacing gradually until it matches the character speed, or jump straight to normal timing once you can copy most letters at that speed?
2. Keys and keyers. A straight key gives you complete control of timing and rhythm, and it is the simplest thing to get on the air with. An iambic keyer with dual-lever paddles generates the dits and dahs for you, and squeezing both levers produces alternating elements. Iambic mode A and mode B differ in what happens when you release a squeeze. In mode B the keyer sends one more opposite element after release. In mode A it stops. Neither is better in general, but if your paddle timing feels "off," check the mode first. A bug (Vibroplex is the best-known maker) makes automatic dits with a pendulum and leaves dahs to your hand, which gives a distinctive swing but takes practice to keep clean. Paddles from various small makers, N3ZN among them, are often discussed for their adjustment range and feel. What would you look at first when choosing: weight, contact adjustment, or lever spacing?
3. Receiver side. A CW filter in the 200 to 500 Hz range is typical. Narrower cuts more noise and QRM, but very narrow settings can make the signal ring, and you may lose callers who are slightly off frequency. Setting your sidetone and receive pitch to the same comfortable note, often somewhere between 500 and 700 Hz, makes it much easier to tune signals to the center of the filter.
4. QSK and break-in. Full QSK lets you hear the other station between your own elements. That is valuable in a pile-up or a contest because you can hear someone else start to call. It needs a transceiver or T/R switching that can keep up, and you have to check that any amplifier is compatible. Semi break-in uses a hang time after you stop sending, which is easier on the hardware but means you miss what happens in the gaps.
5. Decoders and skimmers. CW Skimmer and similar software can decode many signals across a band at once, and the Reverse Beacon Network uses this kind of technology to report spots. Decoders can be a handy aid for finding stations or checking a callsign, but they struggle with fading, noise, and irregular hand-sending. Do you use one as a training check or just to scan activity?
Also welcome: favorite abbreviations, prosign habits (AR, SK, BT, KN and so on), and contest-specific tips such as cut numbers and keeping your exchange clean at speed.
Link to comment
https://www.hamradiobase.com/forums/topic/11209-getting-from-slow-careful-cw-to-relaxed-copy-farnsworth-paddle-settings-filters-and-when-to-trust-a-decoder/Share on other sites