Building a lightweight SOTA/POTA go-kit: EFHW or linked dipole, and how big a LiFePO4 do you really need?
- Replies 2
- Views 28
- Created
- Last Reply
A better way to browse. Learn more.
A full-screen app on your home screen with push notifications, badges and more.
I'm putting together a go-kit that works for both a short hike to a summit and a drive-up park activation, and I keep going back and forth on a few choices. I'd like to hear how others weigh them.
Antenna. The two main contenders are an end-fed half-wave (EFHW) and a center-fed linked dipole. The EFHW is attractive because it's one wire, one matching unit (usually a 49:1 transformer), and a 40 m-resonant length also works on 20, 15 and 10 m through its harmonics. You can hang it as a sloper, an inverted-L or an inverted-V from a single support, and you don't need a tuner on the harmonically related bands. The downsides are that the match depends on the transformer and on what the feedline and counterpoise are doing. A common-mode choke at the radio end is cheap insurance, and a bit of RF in the shack (or on the mic) is a typical symptom of skipping it.
A linked dipole is more fiddly. You have to set or move links for each band and keep the legs the right lengths. In exchange you get a balanced, predictable match and usually a lower SWR across the band without a tuner. It also tends to be a bit quieter on receive. Changing bands means walking out and moving links, though, which gets old when you're hopping between 40 and 20 to chase spots.
Support. A 10 m (about 33 ft) telescopic fiberglass pole is the usual choice. Three practical points: a few guy lines and stakes are worth the weight in any wind, collapsed sections should be cleaned and dry before packing, and the setup must stay well clear of power lines. If you can't get a clean, open spot, a shorter pole with a sloper is often better than fighting a tall pole in trees.
Power. A small LiFePO4 pack is the usual pick because of its flat voltage curve and low weight. A few things to check:
Logging. I'd like to keep a paper log as the primary record, with a phone or laptop app as the convenience layer. Paper doesn't need a battery and survives rain better than most people expect if you use a pencil. Whichever you use, log in UTC, record the park or summit reference and the band and mode, and export an ADIF file so you can upload afterwards. Check the current program rules for how many QSOs make an activation valid and what the upload requirements are, since those can change.
Weather and safety. Tall conductive poles and wires on exposed terrain are a lightning risk. The simple rule is that if you can hear thunder, you're within strike range, so take the antenna down and move to safer ground. Add a plan for wind, cold, and heat, plus enough water. Tell someone where you're going and when you expect to be back.
So, for a first all-round kit, which would you pick: EFHW for simplicity, or linked dipole for predictability? And what battery size has been about right for QRP versus 20 W?
Link to comment
https://www.hamradiobase.com/forums/topic/11258-building-a-lightweight-sotapota-go-kit-efhw-or-linked-dipole-and-how-big-a-lifepo4-do-you-really-need/Share on other sites