Run or hunt? Using rate, multiplier value and SO2R to decide where the next hour goes
- Replies 2
- Views 33
- Created
- Last Reply
Top Posters In This Topic
-
Admin_Terry 1 post
-
Mod_Chad 1 post
A better way to browse. Learn more.
A full-screen app on your home screen with push notifications, badges and more.
This is a discussion starter on the decision that shapes most contest scores: when to keep running, when to leave and tune for multipliers, and when to change bands. It applies to CW, SSB and RTTY, from a small single-op station to a serious SO2R setup.
A rough framework to pick apart: in a contest where score is QSO points times multipliers, a new QSO is worth your current multiplier count, and a new multiplier is worth your current QSO point total. So one multiplier is worth about (QSO points / multipliers) ordinary QSOs. Early on, the multiplier count is small and that ratio is large, so hunting for new mults pays. Later the ratio shrinks, and a strong run on a band with good rate often beats spending ten minutes chasing one more mult. Many contests use other formulas, such as per-band multipliers, fixed point values by distance or continent, and bonus points. Work out the real marginal value from the rules before you trust any rule of thumb.
Rate is the other half. N1MM Logger+ shows rolling rate figures, and they only help if you compare them with an alternative. If you are running 90 an hour on 20 meters and the rate has sagged to 60, is the band fading, is your frequency getting crowded, or is it just a lull? A short S&P sweep tells you what the other bands offer. Without that comparison it is easy to stay too long on a dying run or jump around too often.
Questions for the thread:
1. How do you decide when a run has stopped being worth it? A fixed rate threshold, a drop over a set number of minutes, or the number of new callers per CQ?
2. How do you handle the assisted versus unassisted line? Local CW Skimmer decoding, the Reverse Beacon Network and packet clusters are treated differently depending on the contest and category, so read the rules for your event and class instead of assuming. Which tools do you actually lean on when they are allowed?
3. For SO2R, what keeps the second radio productive without wrecking the run on the first?
4. Where do fatigue and band-change limits fit into your plan? Some multi-operator categories restrict how often you can change bands, and a plan that ignores them can cost you.
Link to comment
https://www.hamradiobase.com/forums/topic/11265-run-or-hunt-using-rate-multiplier-value-and-so2r-to-decide-where-the-next-hour-goes/Share on other sites