Skip to content
View in the app

A better way to browse. Learn more.

Ham Radio Base

A full-screen app on your home screen with push notifications, badges and more.

To install this app on iOS and iPadOS
  1. Tap the Share icon in Safari
  2. Scroll the menu and tap Add to Home Screen.
  3. Tap Add in the top-right corner.
To install this app on Android
  1. Tap the 3-dot menu (⋮) in the top-right corner of the browser.
  2. Tap Add to Home screen or Install app.
  3. Confirm by tapping Install.
Ham Radio Base — Education, Resources, Projects and Community
☀ Solar
SFI 99
SN 26
A 6
K 0 Quiet
X-Ray B2.3
Wind 384.8 km/s
Aurora 1
Updated 13:30 UTC HamQSL · N0NBH
Day 80/40m Good 30/20m Good 17/15m Fair 12/10m Poor
Night 80/40m Good 30/20m Good 17/15m Fair 12/10m Poor

Callsign Lookup
_
Vanity Call Signs Available
Enter filters above and click Search.
ⓘ Callsign lookups are in real time via the FCC database. Vanity callsign availability is refreshed daily at 6:00 AM CST. The vanity search may be unavailable for a few minutes during this update.
Live DX spots
Live DX Spots — 70cm via PSKReporter · scroll or pinch to zoom
Band
Mode
Time
Loading map data…
MHz DX Spotter Info
Recent spots —
Select a band above to load spots
Ready — select a band to fetch live spots

Run vs. S&P with SO2R: how do you decide when to leave your run frequency for multipliers?

ci_cover.jpg

I'd like to compare notes on the decision framework for running versus search and pounce, especially once a second radio is involved. The textbook answer is "run when your run rate beats your S&P rate," but in practice the comparison is murky. A run rate of 90/hr that decays to 50/hr as the band ages is a different situation from a steady 60/hr, and S&P rate depends heavily on how many unworked stations are tuneable at that moment.

Here are the pieces I'd like to talk through:

1. Rate vs. multiplier value. In a contest where each new multiplier is worth a large share of your current QSO count (early in a multiplier-per-band contest, for instance), a 30-second excursion to grab a mult can be worth more than 30 seconds of CQing. Late in the contest, when most mults are worked, the same excursion is worth far less. Is anyone using an explicit rule of thumb, such as "leave the run only if the mult is worth more than N QSOs"?

2. SO2R and what the second radio should be doing. Radio 2 can listen for mults on another band while radio 1 runs. The usual failure mode is that radio 2 steals attention from the run and your CQ cadence slows. Some operators prefer a strict discipline: radio 2 only gets attention in the gap after a CQ, and only if the bandmap shows something worth the trip.

3. Logging software setup. N1MM Logger+ supports SO2R operation with a bandmap per radio, and it has a 2BSIQ mode where you can work two bands in a more interleaved way. For classic SO2R, the real work is in the hardware: a proper SO2R box or controller, band-pass filters or stub filters to keep radio 1's transmit from desensing radio 2, and transmit inhibit/interlocks so you never key both rigs on the same band by accident.

4. Spotting. With assisted categories, packet/cluster spots and Reverse Beacon Network spots (from CW Skimmer-style decoders) feed the bandmap, so S&P becomes largely a matter of clicking through. In unassisted categories none of that is allowed, so you work the dial by hand and your S&P rate drops accordingly. Always check your contest's rules on what counts as assistance. The category you enter changes the optimal run/S&P balance.

Where do you set the threshold for leaving a run, and how do you keep the second radio from hurting your run rate?

  • Replies 2
  • Views 29
  • Created
  • Last Reply

Top Posters In This Topic

Featured Replies

  • Moderators

One way to frame it is in terms of marginal rate. Pull up the rate window in your logger (N1MM shows 10-minute and 60-minute rates, among others) and treat the last 10 minutes of your run as the number to beat. If you're pulling in QSOs at something like 1.2 per minute, then every minute spent off the run frequency costs you roughly 1.2 contacts, plus whatever you lose to your frequency being taken over by someone else. The cost of leaving is greater than just the time away, which is why a lot of operators won't leave a strong run for a single ordinary multiplier but will leave for a rare or double-credit one.

The frequency risk is also why SO2R changes the answer. With a second radio you can keep CQing on radio 1 while radio 2 tunes, so the "cost" of looking for a mult is mostly attention rather than lost CQs. The usual discipline is to let radio 1 run its message, then glance at radio 2 only during the listening window after the CQ. If the stations on radio 1 are coming back at a steady clip, radio 2 stays quiet; when radio 1 slows, radio 2 gets more time.

On the hardware side, the part that tends to cause the most trouble is receive isolation, not logging. If both radios are on bands close in frequency, or if antennas are physically near each other, the transmit signal will either overload the other receiver or leave you with a noise floor full of splatter. Band-pass filters on each rig, adequate antenna separation, and a controller with proper headphone switching (stereo split, or mono on one ear) are what make SO2R usable. Practice the headphone setup before the contest, because it takes time to learn to keep two audio streams straight.

One more point on multipliers: the best time to work mults is usually when the band is slow for running anyway. Plan band changes around openings (grayline paths, the long haul to a particular region) rather than the clock, and use your second radio to check a band for a multiplier opening before you move the main radio there.

  • Administrators

Adding the pieces that tend to get left out of run-vs-S&P discussions: category, antennas, and endurance.

Category first. If you're in an assisted category, a skimmer feed and cluster spots let you build a mult list quickly. Since RBN-style spots can include spots for your own callsign, you can also see where your signal is being heard, which is useful for deciding whether to keep running or QSY. In unassisted categories none of that is available, so S&P takes longer and a good running frequency becomes more valuable. Overlay categories (like some Classic or Rookie-type categories in various contests) change the equation again, so read the rules for the specific contest rather than assuming.

Antennas. Running rate depends heavily on how well you can be heard, and in contest conditions a modest gain advantage can mean a clearly different rate. For the higher bands, stacked yagis let you pick takeoff angles that suit the path, with the low stack for short skip and the high one for long haul. On the low bands, a separate receive antenna such as a Beverage or similar directional receive antenna can matter more than a bigger transmit antenna, because it lets you hear weak callers under the noise. Whatever you have, an antenna switch that lets you change quickly without thinking is worth more than a theoretical extra dB you can't use fast.

Band changes and rules. Some contests restrict how often multi-operator stations can change bands (the 10-minute rule in some CQ WW categories is a typical example), but single operators generally have more freedom. Even so, constantly moving costs you your run frequency each time, so the best approach is often to commit to a band while it is productive and move when the rate really drops, rather than chasing each spot.

Fatigue. In a 48-hour contest the biggest errors are usually late: logging the wrong callsign, sending the wrong exchange, missing a band that's opening. Plan your off-time in advance and put your breaks where the rate is poorest, such as the dead hours on your main band, rather than whenever you feel tired. Keep water and food within reach so you don't have to leave the chair. If you use SO2R, remember it is more mentally demanding than single-radio operating, and an operator who gets tired should be willing to drop back to one radio and keep the log clean.

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

Affiliate Disclosure: As an Amazon Associate, Ham Radio Base earns from qualifying purchases. Some links throughout this website may be affiliate links. If you purchase a product through one of these links, we may earn a commission at no additional cost to you. Your support helps us continue creating free articles, tutorials, reviews, and resources for the amateur radio community. N0TLB © Ham Radio Base - Powered by the Ham CQ DX Community. All rights reserved.

Search

Search

Configure browser push notifications

Chrome (Android)
  1. Tap the lock icon next to the address bar.
  2. Tap Permissions → Notifications.
  3. Adjust your preference.
Chrome (Desktop)
  1. Click the padlock icon in the address bar.
  2. Select Site settings.
  3. Find Notifications and adjust your preference.