Skip to content
View in the app

A better way to browse. Learn more.

Ham Radio Base

A full-screen app on your home screen with push notifications, badges and more.

To install this app on iOS and iPadOS
  1. Tap the Share icon in Safari
  2. Scroll the menu and tap Add to Home Screen.
  3. Tap Add in the top-right corner.
To install this app on Android
  1. Tap the 3-dot menu (⋮) in the top-right corner of the browser.
  2. Tap Add to Home screen or Install app.
  3. Confirm by tapping Install.
Ham Radio Base — Education, Resources, Projects and Community
☀ Solar
SFI 99
SN 26
A 6
K 0 Quiet
X-Ray B2.3
Wind 384.8 km/s
Aurora 1
Updated 13:30 UTC HamQSL · N0NBH
Day 80/40m Good 30/20m Good 17/15m Fair 12/10m Poor
Night 80/40m Good 30/20m Good 17/15m Fair 12/10m Poor

Callsign Lookup
_
Vanity Call Signs Available
Enter filters above and click Search.
ⓘ Callsign lookups are in real time via the FCC database. Vanity callsign availability is refreshed daily at 6:00 AM CST. The vanity search may be unavailable for a few minutes during this update.
Live DX spots
Live DX Spots — 70cm via PSKReporter · scroll or pinch to zoom
Band
Mode
Time
Loading map data…
MHz DX Spotter Info
Recent spots —
Select a band above to load spots
Ready — select a band to fetch live spots

Building a lightweight activation kit: EFHW or linked dipole, and how to power it

ci_cover.jpg

I'd like to compare notes on setting up a portable kit that works for both summit and park activations without turning into a 20 kg pack. The pieces I keep seeing debated are the antenna (end-fed half-wave versus a linked dipole), the support (a telescopic fiberglass pole versus a tree), the power (a small LiFePO4 battery, with or without solar), and how to keep a clean log when your hands are cold and the pileup is loud.

On antennas, an EFHW is popular because it's one wire plus a matching unit, usually a 49:1 transformer. A wire cut for 40 m is roughly 20 m long and also works on 20, 15 and 10 m through its harmonics. You only need one high support point and the far end can slope away, which is handy in a crowded park. The tradeoffs are that it relies on a counterpoise or the coax shield, so a common-mode choke at the radio end is worth having, and that the matching unit gets warm if you run real power on a mismatched band.

A linked dipole is simpler electrically. It's a center-fed resonant antenna with links, usually small connectors, that you open or close to change bands. It tends to behave predictably and needs no tuner, but it needs two legs, a center support, and a minute or two of fiddling every time you change band. In a wet field with cold fingers, that can be annoying.

For power, a LiFePO4 pack has a nice flat voltage curve and is safer than most other lithium chemistries. Plan for the radio's real current draw. A 100 W rig can pull around 20 A on transmit, while a 5 W QRP rig is a small fraction of that, so capacity needs differ a lot by mode and power level. Also keep in mind that LiFePO4 shouldn't be charged below freezing unless the BMS explicitly allows it, which matters if you're using solar in cold weather.

What's your general approach to balancing weight against reliability? Do you carry a backup antenna, and what do you do about logging? I'm particularly interested in how people handle the paper-versus-app question.

  • Replies 2
  • Views 30
  • Created
  • Last Reply

Top Posters In This Topic

Featured Replies

  • Moderators

One framework that helps is to decide your limiting factor first. For SOTA, it's usually weight and weather exposure, so a QRP rig, a roughly 10 m pole or a tree, and an EFHW are a common combination. For POTA from a car or picnic table, weight matters much less, so you can bring a bigger battery, a 100 W radio, and a more comfortable antenna setup.

On the EFHW versus linked dipole question, a lot comes down to how many bands you actually plan to use. If you mostly run 40 and 20 m, a linked dipole is perfectly good and straightforward. If you like hopping around, an EFHW saves handling time. Either way, bring a spare length of coax and a few cable ties, because those are the failure points that tend to end an activation more than the radio does.

For batteries, size the pack from a rough calculation: average current times operating hours, with a margin. Transmit time is only part of a typical session, and receive current adds up over several hours. With solar, make sure the charge controller is set for LiFePO4 and don't rely on it to keep the pack full on a cloudy day. Treat solar as a bonus, not a plan.

  • Moderators

On logging, many operators write on paper first and transcribe later, because a phone can fail from cold, low battery, glare or rain. If you use an app, keep a paper backup of callsigns, times in UTC, band and mode, and the park or summit reference. For POTA, a valid activation usually requires a minimum number of contacts within a single UTC day, and SOTA has its own point thresholds and activation zone rules. Check the current official rules before you head out, since programs update them.

On weather and safety, a telescopic pole and a long wire are not what you want near lightning. A common rule is to take down the antenna and leave exposed ground as soon as thunder is audible. Wind is the other pole killer, since a fully extended fiberglass pole with a wire on top catches a lot of it. Guy lines, or simply a shorter extension, can save the day. It's also worth telling someone where you're going and when you'll be back, and carrying extra layers, water and a way to call for help that doesn't depend on the radio you're operating.

For Field Day style setups, the same ideas scale up: separate power sources for radios, a clear tent or shelter layout, and good cable management so nobody trips over coax. A simple checklist taped inside the go-box catches most forgotten items.

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

Affiliate Disclosure: As an Amazon Associate, Ham Radio Base earns from qualifying purchases. Some links throughout this website may be affiliate links. If you purchase a product through one of these links, we may earn a commission at no additional cost to you. Your support helps us continue creating free articles, tutorials, reviews, and resources for the amateur radio community. N0TLB © Ham Radio Base - Powered by the Ham CQ DX Community. All rights reserved.

Search

Search

Configure browser push notifications

Chrome (Android)
  1. Tap the lock icon next to the address bar.
  2. Tap Permissions → Notifications.
  3. Adjust your preference.
Chrome (Desktop)
  1. Click the padlock icon in the address bar.
  2. Select Site settings.
  3. Find Notifications and adjust your preference.