How do you decide if a band is really open: SFI/K-index, or WSPR and beacons first?
- Replies 2
- Views 13
- Created
- Last Reply
Top Posters In This Topic
-
Mod_Chrissy 1 post
-
Mod_Nancy 1 post
A better way to browse. Learn more.
A full-screen app on your home screen with push notifications, badges and more.
I'd like to compare workflows for judging HF and VHF conditions. The numbers on the solar-terrestrial pages (SFI, A index, K index) are useful, but they don't always match what you hear on the antenna. A band can look great on paper and sound dead. Another can look marginal and still produce a surprise opening.
This is the rough mental model I use. Corrections are welcome.
Solar flux (SFI) is the 10.7 cm radio flux. It's a proxy for how much ionizing radiation is reaching the F layer, so higher values generally mean a higher MUF. It is a smoothed, indirect measure, though, and it says nothing about your specific path.
A and K indices describe geomagnetic disturbance. K is a 3-hour value on a 0-9 scale. A is a daily figure derived from it. Low, steady values usually mean stable paths. Rising K tends to hit high-latitude and transpolar paths first, with flutter, absorption and depressed MUF.
The D layer is the daytime absorber. It mostly eats 160, 80 and 40 m during daylight and fades after sunset. That's why low-band DX comes alive near the gray line, where your end is dark and the far end is still in transition.
The F layer sets the MUF. A path can work well below the MUF, and the usual rule of thumb is to operate somewhat below it for reliability (the FOT is commonly taken as about 85% of the MUF). Above the MUF, signals just pass through.
Then there are the "non-solar" modes. Sporadic E gives short-skip and multi-hop openings on 10 m, 6 m and sometimes 2 m, mostly in the early summer season. Tropospheric ducting depends on weather, usually temperature inversions under high pressure or over water, and affects VHF/UHF. Neither one follows the sunspot number.
For checking the band in real time, my toolbox is:
When the indices and the real-time tools disagree, which do you trust? And do you have a routine for NVIS, where the question is more about foF2 and absorption than about DX?
Link to comment
https://www.hamradiobase.com/forums/topic/11742-how-do-you-decide-if-a-band-is-really-open-sfik-index-or-wspr-and-beacons-first/Share on other sites