Skip to content
View in the app

A better way to browse. Learn more.

Ham Radio Base

A full-screen app on your home screen with push notifications, badges and more.

To install this app on iOS and iPadOS
  1. Tap the Share icon in Safari
  2. Scroll the menu and tap Add to Home Screen.
  3. Tap Add in the top-right corner.
To install this app on Android
  1. Tap the 3-dot menu (⋮) in the top-right corner of the browser.
  2. Tap Add to Home screen or Install app.
  3. Confirm by tapping Install.
Ham Radio Base — Education, Resources, Projects and Community
☀ Solar
SFI 99
SN 26
A 6
K 0 Quiet
X-Ray B2.3
Wind 412.9 km/s
Aurora 1
Updated 14:00 UTC HamQSL · N0NBH
Day 80/40m Good 30/20m Good 17/15m Fair 12/10m Poor
Night 80/40m Good 30/20m Good 17/15m Fair 12/10m Poor

Callsign Lookup
_
Vanity Call Signs Available
Enter filters above and click Search.
ⓘ Callsign lookups are in real time via the FCC database. Vanity callsign availability is refreshed daily at 6:00 AM CST. The vanity search may be unavailable for a few minutes during this update.
Live DX spots
Live DX Spots — 70cm via PSKReporter · scroll or pinch to zoom
Band
Mode
Time
Loading map data…
MHz DX Spotter Info
Recent spots —
Select a band above to load spots
Ready — select a band to fetch live spots

Building a go-kit that works for both SOTA and POTA: where do you trim weight and where do you not?

ci_cover.jpg

Let's talk about go-kit philosophy. A kit that is fine for a drive-up park activation can be miserable on a summit hike, and a kit stripped for a summit can be annoying at a picnic table. Most people end up with a core kit plus a few swap-in pieces. Here is a baseline to poke holes in.

Radio: a 5 to 10 W QRP rig or a 20 W class rig, depending on the band conditions you expect. For SSB from a park, extra power helps. For CW or digital on a summit, QRP is usually enough and the weight savings are real. Antenna: an end-fed half wave (EFHW) on a 49:1 style transformer is the usual starting point, because it is light, resonant on the fundamental and its harmonics, and can be hung as a sloper or inverted V from a single support. A 10 m (33 ft) telescopic fiberglass pole is a common support. Power: a small LiFePO4 pack, with fuse and cable that match the rig's current draw.

The things I would not cut are the ones that fail quietly: a fused power lead, a short coax jumper, a spare connector adapter or two, a paper log and pencil, a few meters of cord for guying the pole, and some basic weather gear. The things I would happily trim are the second antenna you will not put up, the big paddle or keyer you do not need, and the oversized battery for a two-hour activation.

A few questions to get things going. Do you carry a separate resonant antenna per band or rely on one multiband wire? How do you keep a telescopic pole upright in rocky ground or wind? And what is your rule for when to pack up because of weather? Share setups, not just gear lists, and say what you would change.

  • Replies 2
  • Views 34
  • Created
  • Last Reply

Top Posters In This Topic

Featured Replies

  • Moderators

On the antenna side, the main thing with an EFHW is that the feedpoint impedance is very high, in the range of a couple of thousand ohms, so the transformer and the feedline matter more than people expect. These antennas usually have no true ground or counterpoise, so the coax shield often becomes part of the antenna. That is why you will see common-mode current: RF on the shack side, a rig that misbehaves, or a SWR reading that changes when you touch the coax. A small choke near the transformer, or a few turns of coax on a ferrite, is cheap insurance. Keep the radiating wire clear of the pole where you can, since a wet or lossy fiberglass pole or nearby foliage will pull the resonance down in frequency.

Linked dipoles are the other camp. They are resonant on each band with links that you open or close, which means you walk to the antenna to change bands, but you get a balanced antenna with predictable behavior and can often run without a tuner. For a single-band park activation that is fine. For band hopping to chase contacts it gets old quickly. An EFHW with a tuner or one that is cut for 40, 20, 15 and 10 m is more convenient, though it is worth checking the SWR on each band before the hike, since trimming in a field is harder than in a backyard.

For the pole, guying at the top section or just below the thinnest joint helps a lot. The upper sections are the weak part, so many people set the pole slightly shorter than its maximum and leave the last section partly collapsed. Hose clamps or tape on the joints keep sections from creeping down. Avoid any overhead power lines, and never put up a pole when thunderstorms are anywhere near.

  • Moderators

Power and logging are where small choices pay off. With LiFePO4 the nominal voltage is about 12.8 V, with a full charge around 14.4 to 14.6 V on a 4-cell pack. Many rigs tolerate that, but check your radio's rated input range. Some rigs go into protection or lose output near the upper edge, so a voltage that sags under transmit load is not necessarily a problem, whereas a pack that sits at the top of the range could be. Put a fuse close to the battery, use cable that is thick enough for the transmit current, and know what the battery's BMS does at low voltage: some just cut off with no warning mid-QSO. Also avoid charging lithium cells below freezing unless the pack explicitly has low-temperature charge protection.

For solar, a small panel with an MPPT charge controller that has a LiFePO4 profile is a better match than a simple panel wired straight to the battery. In practice, many people carry solar to top off between trips or to run a small station for longer events, not to power a QRP activation that lasts a couple of hours. For Field Day-style setups the same principle applies at larger scale: separate generators or large batteries from receive antennas, because switching supplies and engines are noisy.

Logging: keep a paper backup even if you use an app. Phones die in the cold, and screens are hard to read in sun or rain. Write down time in UTC, callsign, band and mode, and RST. Both programs have their own thresholds, so check the current rules for your program: a POTA activation needs a minimum number of contacts, and SOTA has its own minimum and boundary rules for the activation zone. It also helps to record your location, park or summit reference, and weather notes. Finally, treat weather as a go/no-go item: if thunder is audible or storms are building, stop, collapse the antenna and move to safe ground, because a QSO is not worth the risk.

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

Affiliate Disclosure: As an Amazon Associate, Ham Radio Base earns from qualifying purchases. Some links throughout this website may be affiliate links. If you purchase a product through one of these links, we may earn a commission at no additional cost to you. Your support helps us continue creating free articles, tutorials, reviews, and resources for the amateur radio community. N0TLB © Ham Radio Base - Powered by the Ham CQ DX Community. All rights reserved.

Search

Search

Configure browser push notifications

Chrome (Android)
  1. Tap the lock icon next to the address bar.
  2. Tap Permissions → Notifications.
  3. Adjust your preference.
Chrome (Desktop)
  1. Click the padlock icon in the address bar.
  2. Select Site settings.
  3. Find Notifications and adjust your preference.